Installing Temp. Gauge on 96 GT

[JD96GT]

Okay well going to install a Sunpro mechanical water/coolant temperature gauge tommorow morning and wondering if anyone has done this before and can give me some advice or good instructions on how to do this?? Is it possible for me to just put it in place of the temp. sending unit sensor?? Or will that cause problems? Thanks!!!

JD

 

[Miles]

Shouldn't cause an issue, but you can t-junction it with the existing one to be safe.

Be VERY careful though when tightening it as too much PSI will result in a cracked intake (unless you have the PI intake already installed).