I recently changed my valve cover gaskets and when putting the intake back on I put on a new Trickflow intake spacer and gaskets for my GT-40 intake, since I had a hard time getting the gaskets off the one I had on it. I used new gaskets that came with the spacer and plug everything back in. Went to start it up and it lopes bad, is hard to keep running until it warms up. When it does warm up the car idles at 1200 RPM, but seem it sound find but does lack power.
Does anyone have any ideas or had problems with getting the GT 40 intake to seal properly, as this is not the first time I have had this problem. I put 22 ftp on the bolts as the recommended was 18-24, I have tried to listen for a vacum leak but can't find any. I read about a starter fluid technique that I will try tomorrow. Any other help would be helpfull.
Thaks
Does anyone have any ideas or had problems with getting the GT 40 intake to seal properly, as this is not the first time I have had this problem. I put 22 ftp on the bolts as the recommended was 18-24, I have tried to listen for a vacum leak but can't find any. I read about a starter fluid technique that I will try tomorrow. Any other help would be helpfull.
Thaks