It Steers Great... But Doesnt Stop

It always figures... I fixed a problem today with new A-Arm bushings, ball joints and tie rod ends, and then my brakes dont want to work at all. Just a really mushy, pedal to the floor deal. They worked just fine two days ago when I started on the front suspension. Should I try bleeding them first before anything else? I tucked them away behind the strut up under the inner fender above everything else. The brake lines appeared fine, didnt see any leaks. I didnt crack the lines at all, didnt even mess with the brakes except for removing caliper / pads and rotor, and sliding them back on.

Any ideas on it?

On a positive note... the front end feels SOLID now. Amazing difference without all the slop up front.

I never disconnected the calipers... just unbolted the mount and hung them.

I have a deep groove around the drivers rotor now... maybe a pad wasnt in just right... i pulled it apart again and didnt notice anything.


New problem though... just noticed the passenger side tire rubs the a-arm now.

Would that be the tie rod needing to come in a lot more?