• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 2.3L (N/A & Turbo) Tech

Just got my 87 TC

  • Thread starter Thread starter AmMscl
  • Start date Start date Sep 24, 2005
A

AmMscl

Member
Feb 14, 2004
38
0
7
CALI
Sep 24, 2005
#1
  • Sep 24, 2005
  • #1
NooB????s
I just got my 87 TC today, the idle is kind of rough.....but gets better when it reaches OP Temp. What should I see for Vac at idle and what RPM?
One thing I noticed is, it builds boost (up to 10PSI by around 2500-3500) but then starts to fall off way before redline WOT.
I've seen 10PSI at 5500, but car was not pulling very hard (No ping or over heating)
87 TC = 108k on it and no mods (5spd)
Thx
 

Red_LX

I’m not much help unless you’re looking for ****!
Founding Member
Nov 29, 1999
5,896
73
129
Morgantown, WV...where couches meet their doom
Sep 24, 2005
#2
  • Sep 24, 2005
  • #2
Sounds to me like you have a vacuum and/or boost leak somewhere. check the couplings on the intercooler and also check the vacuum lines to make sure none are unhooked or cut.
 
A

AmMscl

Member
Feb 14, 2004
38
0
7
CALI
Sep 24, 2005
#3
  • Sep 24, 2005
  • #3
From what I've been reading, the IHI starts to fall off after 4500-5000 RPMS...is this possibly what I'm experiencing?
Sorry, new to the turbo world...Every supercharger I had pulled all the way to redline?
 

Red_LX

I’m not much help unless you’re looking for ****!
Founding Member
Nov 29, 1999
5,896
73
129
Morgantown, WV...where couches meet their doom
Sep 24, 2005
#4
  • Sep 24, 2005
  • #4
Well I dunno, people have told me that too although my car seemed to pull good clear up to 5000+ RPM and I definitely didn't have the boost fall off at the upper rpm's either.
 
R

ratrapp2

New Member
Jun 24, 2005
121
0
0
Sep 25, 2005
#5
  • Sep 25, 2005
  • #5
is it an a/t car?most a/t cars are limited to 10 psi.your factory boost control solenoid could be going bad as well.we replaced the one on my brothers 88 turbocoupe with the gillis valve,best $45 spent on the car.it's adjustable up to 17/18 psi.also turbo boost does fall off alittle compared to supercharged boost.my brothers car also had a rough idle,his problem was a bad tps and dirty iac.we used a ford tps(these car prefer ford parts,especially plug wires)and cleaned the iac.
 
A

AmMscl

Member
Feb 14, 2004
38
0
7
CALI
Sep 25, 2005
#6
  • Sep 25, 2005
  • #6
red lx: I switched over to premium (switch) and got a pretty good response...still only about 10PSI

ratrapp2:5spd...thanks for the advice I will check those components out
 
You must log in or register to reply here.

Similar threads

A
Engine 1990 Fox wont rev over 3500 RPMS
  • alex.sweitzer
  • Oct 27, 2020
  • Fox 5.0 Mustang Tech
  • 2 3
Replies
57
Views
14K
Fox 5.0 Mustang Tech Mar 21, 2021
alex.sweitzer
A
A
Engine Turbo 5.0 Mustang bad misfire at WOT
  • AwxyMoron
  • Apr 3, 2021
  • Fox 5.0 Mustang Tech
  • 2 3
Replies
51
Views
9K
Fox 5.0 Mustang Tech May 5, 2021
a91what
Engine '93 running rough, especially at low rpm's and idle.
  • evintho
  • Oct 19, 2019
  • Fox 5.0 Mustang Tech
Replies
1
Views
4K
Fox 5.0 Mustang Tech Oct 19, 2019
jrichker
Fox Something Weird Happened Today...related To My Dynotune?
  • killer5.0
  • Oct 19, 2017
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
17
Views
2K
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Oct 23, 2017
killer5.0
J
Is My Gt Normal?
  • jefx
  • Apr 30, 2014
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
4
Views
2K
1996 - 2004 SN95 Mustang -General/Talk- Apr 30, 2014
madspeed
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 2.3L (N/A & Turbo) Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?