k member problem

Djstorm100

Member
Aug 5, 2007
109
0
16
--------------------------------------------------------------------------------

I'm restoring my mustang as is. My plan was going to reuse the stock K-member and re-paint the a-arms and Kmember. When I took it all apart I notice the tabs for the a-arm bolts were bent and out of shape. Well considering my a-arms too were bent. Any who

I then made up my mind to get K-member, Aarms, Coilover kit.

I konw I'm going to get the UPR coilover kit.

As far as K-member/A-arms I've readed many post and still lefted in the middle.

I'm between PA, UPR. I know QA1 is crap and AJE you have to use thier motor mounts.

the brand K-member I go with is the brand A-arms I'll go with as well.
 
QA1 is not crap.Just because it's priced cheaper than most does not mean its junk. I have yet to run into a problem and I have used their entire set up in 3 cars. I currently have a 10sec (on a good day..loll) and was used in an 11 and 12sec street cars as a daily driver (in NYC).I have ordered one for the project I’m working on now. I would love to see one that has failed if anyone can put up a pic.Im a structure engineer for a large firm in NYC and believe this product can with stand more than its given credit for.
 
ET with a k member means nothing for quality. I mean unless you are crash landing the nose after a 6 ft wheelstand, it has little to do with anything.

It's whether or not it can deal with bumps and potholes without the welds breaking.
 
I have heard from many that their UPR was good. I have also heard few say that it is crap, so I am on the fence with them, and I am sticking with my stock stuff.

MM is the best, but that is high priced stuff....and look at EVERY car in their ads in 5.0 mag. They are frickin full blown road race cars!!!! I'm sure you don't need their high priced high quality stuff for the street.
 
Not questioning time's.....Like I said it was on 2 cars that went in and out of NYC (the pot hole capital of the world) 5 days a week with no problems. Just because you pay top dollar for parts does not mean they will be better than the cheaper ones. Once again I would love to see a QA1 broken at the welds from daily driving. I have heard everyone knocking Qa1 products but never saw any proof of their inferior quality.Im not saying mm or any is bad,but why buy a jet engine for a moped?
 
ET's do matter...What keeps that engine from ripping out of the car when you nail the gas to the floor?K-member is mostly an engine support.If your running a full blown race car i would then question the frame.Your strut towers,ball joints and a-arms handles most of the bumps you may aquire.torque from the engine is what matter to the k-frame not so much bumps.
 
I've seen posts in the past where k-member kits have fallen apart on the street. I can't for the life of me remember which kits these were though. I just think with k-members and a-arms it's important to have a good quality kit because your life depends on it.

Daily driving a car is a lot more intense on these parts
 
Alot has to due with alignment also,guys just pop the k-frame in and think it time to rip up the road.It is of such importance to square the frame,but anyway it's been beat to death......Thank guys