LC-1 wiring setup

I searched everywhere and couldn't find anything. I got my LC-1 wideband in yesterday and was looking through the instructions. Well the instructions don't say where to run the different wires to. There are 7 wires, along with 2 stereo cables, one marked serial in, and the other marked serial out. There is also a pushbutton, and a little LED. Now I disconnected my EGR, so I think I can hook this up through the EGR harness right? I'm gonna be running this straight into the twEECer. I don't have a gauge, and don't want one right now. Here's what I have figured out so far:

Red wire: 12v key hot source (pretty simple)
Blue wire: Heater ground (a chassis ground)
White wire: System ground (to the EGR wires?)
Yellow wire: Analog out 1 (EGR harness?)
Brown wire: Analog out 2 (EGR harness?)
Green wire: Analog ground (EGR harness?)
Black wire: Calibration wire (I think it goes to the pushutton, with the LED in the middle)

But I still don't know what the two serial cables are for, or some of the other wires. I know some of you guys are running LC-1's, so is there anyway you can help me out with the wiring setups? Thanks all!
-Chris

blksn955.o said:

There are preaty good details on installing o2 sensors/hardware/hookups on the tweecer forums. Unless they got lost in the board switch.

Click to expand...

I looked around on EECtuning.org and Innovative's forums, but couldn't find much useful info. All they say is to run the analog wires to your datalogger or ECU. WTF??

blksn955.o said:

I realy dont think many people here will have the details on that, cept the master Grady.

Click to expand...

Hopefully he'll chime in and "spoon-feed" me the answers. j/k Grady. I know there are others in here using widebands, it's just a matter of getting this thread to catch their attention.

This is getting pretty far down on the page. Anybody??

blksn955.o said:

I think Darren Woodal(sp?) is the one who has alot of info about hooking up to a 94-95

here is a search I did
http://eectuning.org/forums/search.php?mode=results

Click to expand...

Link doesn't work, it just takes me to the regular search page. I'll see if I can find anything from him though.