lightbar install and holes

[mysticspirit25]

The holes that are drilled into the panels to access the bolts on the lite bar...CDC gives you cheap caps that do not stay put. Is there anyplace that I can get caps to cover the holes that actually have some sort of flange on them so they will stick in the hole, the caps that CDC gives do not have any sort of flange.

 

[Red2000GT]

Sounds like a run to the local parts store and a look through the HELP! section is in order. If that doesn't work,then maybe a little blue or something to hold the caps in place. Not too much to make it permanent but enough to keep them there.

 

[Tstang90]

Hmm I installed a CDC bar on my vert theres no access plugs on mine. But maybe come black silicone will help hold em in so it blends. With your bar. Just prep the surface to remove any armor all etc.

 

[aceman65]

Do you like the loks of the bar? Thinking about getting one.

I used to work at a hardware store and they had round rubber plugs different diameters- flat with a flange lip that would work. You can probably find a plastic one as well pretty easy. Whats the diameter of the hole?

 

[mysticspirit25]

Do you like the loks of the bar? Thinking about getting one.

I used to work at a hardware store and they had round rubber plugs different diameters- flat with a flange lip that would work. You can probably find a plastic one as well pretty easy. Whats the diameter of the hole?

ummm, I love the looks of the bar, I will post a pic of my stang....the hole is a 1" diameter....I am off to home depot to look for rubber plugs.