I bought a set of BBK longtubes used now I need to know what else I need to buy for the install. I know I need gaskets but do I also need O2 Simulators, and Oxygen Sensor Extension Harnesses? My car is a 2000 Mustang GT Automatic.
if you can solder, I would just extend the sensors and make the MIL eliminators yourself, you can save a lot of money. You also need gaskets, get the OEM motorcrafts (~100 a set) and get some heatshielding for your starter. In addition to these, you can also look at getting a set of poly motor mounts since you are in a good position to change them out.
if you can solder, I would just extend the sensors and make the MIL eliminators yourself, you can save a lot of money. You also need gaskets, get the OEM motorcrafts (~100 a set) and get some heatshielding for your starter. In addition to these, you can also look at getting a set of poly motor mounts since you are in a good position to change them out.
^^thank you very much, i think i'm ready to tackle this this weekend. just a few more questions, I need two capacitor's and resistor's right? I Can get these at any of the local parts stores? I'm also putting another tranny in, which should be done first taking out and putting in the new tranny or taking off and putting on the headers? Or does it really matter?
Sorry for all the questions just wanna be well prepared.