Looking for new Manifold to TB Bolts

[Limp Fox]

I'm looking for 4 new bolts with end nuts that screw into the Intake manifold and allow you to slide on a EGR spacer and TB. My stock ones are booger-ed up. Besides going out to Lowes or some thing and trying to match them does any one know where to order them from?

Thanks
Judd

 

[BK_CAULEY]

Trick Flow Specialties TFS-51500093 - Trick Flow® EGR Gasket and Stud Kits - Overview - SummitRacing.com

 

[Limp Fox]

Thank you. I might try lowes or something else tomorrow since there only a a few bucks. If I Can find them for no more then $15 shipped I will get em, but I'm sure Lowes or Fastenal will have them. Again thanks for the link. I will hold on to it

JS

 

[jerryD]

should be 1/4-20 thread.

 

[wythors]

I used hex head cap screws on my GT40 intake. Looks much nicer than studs and nuts.

 

[Limp Fox]

What was the size you got b/c I need it (obviously) to tighten into the manifold and then the 75mm EGR spacer and TB have to go on

 

[wythors]

I don't remember the exact length. Just measure the thickness of your TB and spacer and add a half inch.