Lower intake o-rings question

mustang88

New Member
Nov 2, 2004
69
0
0
lower intake from a 96 explorer ,it has o rings where the injectors go ,some of the orings are missing. can i buy orings from a website? if there is whats the address?

or are the orings from the injectors and stayed in while i pulled them? im not an expert on mustangs yet.

how do i install the new orings and , install injectors? tap them in?

the intake isnt ruined right?
 
OMG, IT'S DESTROYED! :rlaugh: j/k

Those o-rings are off the old injectors. Just pop them out of there, and pop your injectors in. Napa or someplace like that could get you some new o-rings for your injectors if you're worried about them leaking. They should just push into the intake.
 
Fuel injector seal kits with 2 O rings and a pintle cap (Borg-Warner P/N 274081) are available at Pep Boys auto parts. Cost is about $2.74 per kit.. The following are listed at the Borg-Warner site ( http://www.borg-warner.com ) as being resellers of Borg-Warner parts:

http://www.partsplus.com/ or http://www.autovalue.com/ or http://www.pepboys.com/ or http://www.federatedautoparts.com/

Most of the links above have store locators for find a store in your area.

Use motor oil on the O rings when you re-assemble them & everything will slide into place. The gasoline will wash away any excess oil that gets in the wrong places and it will burn up in the combustion chamber.

The pintle caps fit either injectors with a pin sticking out the injector end or 4 with more tiny holes in the injector end