86 mustang 5.0 HO
My manual shows 4 studs for the lower intake, 2 in front, 2 on the passenger side in the middle. I have two. Where do they go and what attaches to them?
TIA
I only recall 2 studs on the lower intake. One is in the second to rear hole on the passenger side to retain the heater feed tube. The other is in the back hole on the drivers side & it is for that brace that goes between the upper & lower intakes. Not real sure what that brace was originally for, but once it comes off, I've never put one back on!
I only recall 2 studs on the lower intake. One is in the second to rear hole on the passenger side to retain the heater feed tube. The other is in the back hole on the drivers side & it is for that brace that goes between the upper & lower intakes. Not real sure what that brace was originally for, but once it comes off, I've never put one back on!
Thanks for the hint! I made a note in my manual. I thought of the brace as more of an electrical connection between the upper and lower when I was taking it off earlier this summer, but didn't write down what was holding in on or even where it went.
Many thanks.