machinist ?

[whiteyford0212]

im picking up a set of iron gt-40's..they have newer valve seals and have been hot tanked at one point...they have a lil bit of surface rust from sitting for awhile..how much do u think it'll cost to get them cleaned up and a slight port n polish at a machinist?

 

[Rick 91GT]

$40-$50 to tank them
$50 or so to glassbead them if you want

Porting is different everywhere depending on how much is done

$100-$150 for a normal 3 angle valve job (may be needed if you start porting)

 

[whiteyford0212]

thanks alot..anyone else have any ballpark figures?