• Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech

Motor Slightly Over heating

  • Thread starter Thread starter StangGT96
  • Start date Start date Oct 16, 2006
S

StangGT96

New Member
Jul 1, 2004
94
0
0
El Paso, TX
Oct 16, 2006
#1
  • Oct 16, 2006
  • #1
Well I noticed that my car has been slightly over heating. It used to be steady at the "R" in the NORMAL and now it usually goes to the M. This happens either in traffic or in the highway. I have changed the thermostat and did a radiator flush (used distalled water and consentrated antifreeze). The fan does turn on but I think it turns on too late. I have changed the fan switch and still the same thing. Could the relay be going out? I have checked some ground wires but not all of them. Any other ideas? This happened over night which is the odd thing
 

whyask

New Member
Apr 4, 2005
735
1
0
Sacramento
Oct 16, 2006
#2
  • Oct 16, 2006
  • #2
is your engine throwing codes..??? they may not show up on the dash. Do you have a tuner to check, if not go to Kragen, AutoZone, or Napa they will be nice and check your codes for you...just be patient with them if they have customers.
 
S

StangGT96

New Member
Jul 1, 2004
94
0
0
El Paso, TX
Oct 16, 2006
#3
  • Oct 16, 2006
  • #3
yeah I have a check engine light but it shows a code P1443 which is something else.
 

whyask

New Member
Apr 4, 2005
735
1
0
Sacramento
Oct 16, 2006
#4
  • Oct 16, 2006
  • #4
well if the computers not showing, have you double checked every fuse and relay just in case ..???
 

the98stang

Active Member
Aug 12, 2005
2,408
0
47
Clovis, CA
Oct 17, 2006
#5
  • Oct 17, 2006
  • #5
The stock water temp gauge is a huge POS. Put an Autometer in there and report back. It shouldn't run hotter than 210 degrees.

Maybe some air got into the system. Try burping it. Put the engine on an incline, open up the resevior cap, and rev the engine a little. You might see some air bubbles float out.
 
S

StangGT96

New Member
Jul 1, 2004
94
0
0
El Paso, TX
Oct 17, 2006
#6
  • Oct 17, 2006
  • #6
I tried to "burp" the system and it still does it. I have checked the fuses for the fan but not the relay. Where is the relay located?
 

whyask

New Member
Apr 4, 2005
735
1
0
Sacramento
Oct 17, 2006
#7
  • Oct 17, 2006
  • #7
i have a diagram at work let me check and Ill let you know ASAP
 

whyask

New Member
Apr 4, 2005
735
1
0
Sacramento
Oct 17, 2006
#8
  • Oct 17, 2006
  • #8
i have a diagram at work let me check and Ill let you know ASAP
 
S

StangGT96

New Member
Jul 1, 2004
94
0
0
El Paso, TX
Oct 17, 2006
#9
  • Oct 17, 2006
  • #9
Thanx!!!!
 
You must log in or register to reply here.

Similar threads

Engine 1986 GT Overheating issues
  • 86 5O GT
  • Jan 25, 2026
  • Fox 5.0 Mustang Tech
Replies
18
Views
676
Fox 5.0 Mustang Tech Jan 29, 2026
86 5O GT
M
Resolved 1988 Foxbody - Overheating Summer
  • MDrisc
  • Oct 26, 2025
  • Fox 5.0 Mustang Tech
Replies
16
Views
711
Fox 5.0 Mustang Tech Jul 17, 2026
fasterthangas
F
Still need an Alignment?
  • from6to8
  • Jun 1, 2025
  • 1994 - 1995 Specific Tech
Replies
3
Views
303
1994 - 1995 Specific Tech Jun 2, 2025
AeroCoupe
A
2001 Mustang GT, scorched metal smell and noise from trans/diff?
  • AndyE2255
  • Dec 1, 2025
  • SN95 4.6L Mustang Tech
Replies
4
Views
469
SN95 4.6L Mustang Tech Dec 28, 2025
gkomo
B
'03 GT Fuel Pump/Pressure/Delivery Issue
  • Brodach
  • Oct 21, 2025
  • SN95 4.6L Mustang Tech
Replies
8
Views
926
SN95 4.6L Mustang Tech Oct 31, 2025
gkomo
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?