• Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech

Mustang got rear-ended.

  • Thread starter Thread starter 40th GT
  • Start date Start date Nov 15, 2004

40th GT

New Member
Apr 7, 2004
916
0
0
Lawrenceville, GA
Nov 15, 2004
#1
  • Nov 15, 2004
  • #1
So I was stopped on a two lane road waiting for the car in front of me to make a left turn into a different road. The car behind me was coming at about 60-65 (45 mph limit) and didn't have enough time to stop because apparently he wasn't paying attention (most likely DUI). His airbag deployed and my fuel pump was cut off which makes me think he was going at least 35mph at the point of impact. The left tailpipe is fubar'd and I'm wondering if there is/are any mechanical parts that could be damaged? (ex. rear end assy, other drivetrain parts) Right now it is at the body shop and the body/frame is getting checked out. I never had a chance to drive it since I got the car towed to the shop.
 

jmk97GT

Member
Oct 29, 2004
178
0
16
Nov 15, 2004
#2
  • Nov 15, 2004
  • #2
Depends on how far in the guy smashed your car in. Your axle SHOULD be fine if he was goin around 35, but I'm sure the body shop will check up on this...Also when you drive it again once it is repaired I'm sure you'd know if the axle was bent

Sorry about the bad luck, I'm always worried about dumbasses doing the same thing to my pony.

Hope it all works out alright and your car gets back to standard
 

RTRMustangGT

New Member
Sep 30, 2004
43
0
0
Nov 15, 2004
#3
  • Nov 15, 2004
  • #3
Hey man i like your christmas song on your webpage. I have a few guys that have rice and i am going to send them that. I hope everything works out for you car. It looked real good. There is not really any mechanical parts in the back of the car to damage until you get to the rear axle other than the fuel tank and pump. Make sure the body shop checks the frame really good. A bent frame can cause all kinds of problems down the road. Good luck with the repairs.
 

Evenflow

yellow snow cone lover
Nov 4, 2004
116
0
16
Mass
Nov 15, 2004
#4
  • Nov 15, 2004
  • #4
Sorry to hear that man..

..One minute ur helping me with the 5 speed, the next minute ur mustang gets rear-ended.

Hope everything turns out ok
 

01GT eibach

Active Member
Nov 18, 2002
1,075
0
36
Pittsburgh, PA
Nov 15, 2004
#5
  • Nov 15, 2004
  • #5
Make sure that the suspension parts are not bent. Can you get a rear Saleen bumper and new catback out of the deal? The other dude's insurance is going to kick in to pay, right?
 

40th GT

New Member
Apr 7, 2004
916
0
0
Lawrenceville, GA
Nov 15, 2004
#6
  • Nov 15, 2004
  • #6
01GT eibach said:
Make sure that the suspension parts are not bent. Can you get a rear Saleen bumper and new catback out of the deal? The other dude's insurance is going to kick in to pay, right?
Click to expand...

Yes, their insurance is paying everything from the chiropractor (my neck is screwed) to the repair bills. I might be able to gain some extra $$ out of this since I'm hiring a lawyer. And yes, I'm trying to get a Magnaflow catback or a Borla stinger out of this deal (see my other post ) http://forums.stangnet.com/showthread.php?t=518037

And thank you all for wishing me luck. I hope everything works out too.
 
P

PEWTERPONY

Founding Member
May 22, 2002
829
0
0
NE Atlanta
Nov 15, 2004
#7
  • Nov 15, 2004
  • #7
No way you're gona bend the axel via direct hit in the back. You'd have to hit it on either side to bend it. TRUST ME.......I KNOW driving them stangs is a bitch in the rain
 
R

ringmaster

New Member
May 16, 2003
14
0
0
Nov 15, 2004
#8
  • Nov 15, 2004
  • #8
man that sucks. i have a mint set of tail lights.
 

dsg_gt2004

New Member
Mar 23, 2004
423
0
0
Georgetown,SC
Nov 16, 2004
#9
  • Nov 16, 2004
  • #9
did i just hear someone might be getting a cobra
 
H

Hoppy

Founding Member
Jun 24, 2002
329
0
0
L.A. CA
Nov 17, 2004
#10
  • Nov 17, 2004
  • #10
I was rear ended in my 95GT.

Look at your exhaust and see how far ir was pushed in (if at all).

Inspect the shock and ESPECIALLY the brake lines.

I went to a body shop that just hung parts to make a quick buck....they missed this. The brakes lost fluid through a small erossion type puncture caused by contacting the exhaust.

Hop
 
F

FalconGuy016

New Member
Oct 26, 2004
437
1
0
Northern VA
Nov 17, 2004
#11
  • Nov 17, 2004
  • #11
I'd worry about the frame and the possible problems that can create... (if you havent seen my worry thread about all that ) Check all your car seams, door jambs, trunk, hood, how they close and open, drive over speedbumps slowly and see if there is a different or bad flex, different angles, etc.
 
You must log in or register to reply here.

Similar threads

K
Engine 2000 Mustang GT - Fuel issue post-blown spark plug repair
  • kenster1092
  • Feb 26, 2026
  • SN95 4.6L Mustang Tech
Replies
4
Views
342
SN95 4.6L Mustang Tech Mar 10, 2026
kenster1092
K
For Sale 2000 GT CONV 4.6 5 SP remaining suspension parts from donor
  • Tods Hot Rods
  • Sep 17, 2024
  • Suspension Parts
Replies
0
Views
312
Suspension Parts Sep 17, 2024
Tods Hot Rods
R
8.8 rear end for '67 coupe, shortened - next steps
  • rubendenver
  • Dec 15, 2024
  • 1965 - 1973 Classic Mustangs -General/Talk-
Replies
2
Views
737
1965 - 1973 Classic Mustangs -General/Talk- Jan 8, 2025
GOvert
G
For Sale 99-04 GT 4.6 CONV COUPE COBRA SET OF 4 FRONT/REAR SPRINGS. TODS HOT RODS MOORPARK CA 93021 $225
  • Tods Hot Rods
  • Nov 20, 2024
  • Suspension Parts
Replies
1
Views
392
Suspension Parts Dec 12, 2024
caliber92
For Sale 2000 GT Conv 4.6 block, heads lots of misc engine parts all removed,degreased, cleaned and inspected.
  • Tods Hot Rods
  • Sep 17, 2024
  • Engine and Power Adder Parts
Replies
3
Views
684
Engine and Power Adder Parts Sep 19, 2024
Tods Hot Rods
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?