Need a little help with quadrant, cable, and adjuster install.

Take out the drivers seat, makes it easier to see what is going on under there. It's a bitch

Disconnect the cable from the clutch fork to give you some slack. Then you can get under the dash and remove the cable from the quadrant. That's the simplest way that I know of. Start at the bottom to remove the old factory "junk"....then work your way up. Install the new from the inside out..
should be about a 30 minute job..


Jim

Dikes. Definately the easiest. Dike it off, and use a new cable. otherwise, yes- what 88gt said. The quadrant is held on with two cotter pin/ spring clip type things- if you take them out and slide the quadrant off first, you can easily remove the cable without jacking up the car. This goes for getting the new quadrant in too- hook the cable on the new quadrant on the pickup you want, slap a piece of electrical tape over it to keep it from popping off, and slide the quadrant on to the posts and you're done no sweat. Oh, not that you don't already know this, but make sure the firewall adjuster is screwed all the way into the firewall first to.