Need fast respaunce please

[mat82284]

i installed a ford raceing throttle body but i dont see a way to ajust the idle its set at 1000 and i need to set it lower. where is the screw to ajust the throttle? anyone else have this tb and know where it is and is it a philps or flat head or allen?

 

[Kilgore Trout]

What is the year of your car?

 

[Kilgore Trout]

Did you reset the PCM after the install and give it time to re-learn fuel trim?

The idle is adjusted electronically not by a screw like it was on the 5.0s

 

[OUR01GT]

i installed a ford raceing throttle body but i dont see a way to ajust the idle its set at 1000 and i need to set it lower. where is the screw to ajust the throttle? anyone else have this tb and know where it is and is it a philps or flat head or allen?

What was your idle before you swapped throttle bodies? I disconnected the battery when I swapped mine and reconnected after the install was complete and it ran great. It sounds like you might have a leak somewhere.

 

[Kilgore Trout]

Hmmm, usually when people put "need fast response" in the thread title, they stick around on the thread... Hellloooo, are you out there man...?

He's probably resetting his PCM...

 

[OUR01GT]

Hmmm, usually when people put "need fast response" in the thread title, they stick around on the thread... Hellloooo, are you out there man...?

He's probably resetting his PCM...

 

[mrvax]

I guess the answer didn't come fast enough. Oh well.

 

[Jones331]

The tps screw is on top of the t.b and it comes pre-set so unplug you computer and reset the memory

 

[mdvaldosta]

the idle will come down after a few times driving the car. make sure you reset the computer, either by pulling the fuse or battery cable.

 

[DerekStangGT]

Hmmm, usually when people put "need fast response" in the thread title....

you are wrong sir, he wrote "Need fast respaunce please"
im still trying to figure out what a "respaunce" is

 

[jivepepper]

you are wrong sir, he wrote "Need fast respaunce please"
im still trying to figure out what a "respaunce" is

He's French.

 

[mat82284]

sorry about that my internet went down you know comcast blackouts. anyways i did reset the computer and the idle is at 900 now wish it would go to 800 also the rpms hang they come down slowly and earlyer it got stuck at 1800 rpms what would cause this how do i fix it? i pulled codes and nothing?

 

[mogs01gt]

you may want to take a piece of sandpaper and clean out the inside of the throttle body around the butterfly. This will make sure no burrs are holding it open.