• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

need help, car wont start.

  • Thread starter Thread starter mob
  • Start date Start date Jan 2, 2008

mob

the guy who hits on his mom
20+ Year Stangneter
Oct 3, 2003
2,566
136
104
Dallas, TX
Jan 2, 2008
#1
  • Jan 2, 2008
  • #1
Hey guys, It was so cold outside today, but the car was running fine from 9am to around 2pm, Went to start the car at around 2:45 to go to work and it wouldnt start. I turned the ignition on and there was power. But when I went past that its like the car just dies, the beeping slows to a stop and theres no power. Tried jumping it and wouldnt start. Checked some of the main grounds and their all fine. What else could this be? First time I try to turn it over itll click once then die, after that it dosent click, unless I leave it for a few minutes, then itll click once again but just die. Fuel pump primes. help please.
 

jrichker

StangNet's favorite TOOL
In Remembrance. Thank you for your contributions
Mar 10, 2000
27,512
2,813
234
Dublin GA
Jan 2, 2008
#2
  • Jan 2, 2008
  • #2
No Crank checklist for 5.0 Mustangs

Since some of the tests will bypass the safety interlocks, make sure that the car is in neutral and the parking brake is set. Becoming a pancake isn’t part of the repair process…

Check battery, terminal connections, ground, starter relay switch (also known as solenoid) and starter in that order. The clamp on with 2 bolts battery terminal ends are a know problem causer.

A voltmeter is handy if you are familiar with how to use it to find bad connections. Measure the voltage drop across a connection while trying to start the car: more than .5 volts across a connection indicates a problem.
See http://www.fluke.com/application_notes/automotive/circuit.asp?AGID=1&SID=103 for help for help troubleshooting voltage drops across grounds.


1.) Will the car start if it is jumped? Then clean battery terminals and check battery.

2.) Check the battery to engine block ground, and the ground behind the engine to the firewall.

3.) Jump the big terminals on the starter relay next to the battery with a screwdriver - watch out for the sparks! If the engine cranks, the starter and power wiring is good. The starter relay is also known as a starter solenoid.

4.) Then pull the small push on connector (small red/blue wire) off the starter solenoid (Looks like it is stuck on a screw). Then jump between the screw and the terminal that is connected to the battery. If it starts, the relay is good and your problem is in the rest of the circuit.

5.) Remember to check the ignition switch, neutral safety switch on auto trans and the clutch safety switch on manual trans cars. If they are good, then you have wiring problems.
Typical start circuit...
Diagram courtesy of Tmoss & Stang&2birds


See http://www.autozone.com/images/cds/gif/large/0900823d80195963.gif for 88-90 year cars
See http://www.autozone.com/images/cds/gif/large/0900823d80195964.gif for 91-93 year cars.
See http://www.autozone.com/servlet/UiB..._us/0900823d/80/1d/db/3c/0900823d801ddb3c.jsp for 94-95 model cars.

6.) The starter may be hung, loosen up the bolts that hold it on, and give it a good whack with a big hammer. Tighten up the bolts and try again.

7.) Pull the starter and take it to Autozone or Pep Boys and have them test it. Starter fails test, then replace it. If you got this far, the starter is probably bad.
 

fastford91

New Member
Aug 15, 2006
254
1
0
Niagara ,Ontario, Canada
Jan 2, 2008
#3
  • Jan 2, 2008
  • #3
i had the same thing happen to me on my old beater car ! it ran fine all the way home from work! took a shower came out to start it and .... NO GO! i checked everything! turned out to be the alternator! id say check that !
 

cenok is family

15 Year Member
Jun 25, 2003
1,409
69
79
Norman, Ok
Jan 2, 2008
#4
  • Jan 2, 2008
  • #4
probably your alternator or battery, more than likely the battery.
 

ryan218

In just 10 years, I'll be old enough to drive!!!!
Dec 28, 2005
0
1
38
columbus ohio
Jan 2, 2008
#5
  • Jan 2, 2008
  • #5
my guess is the battery its to cold for it. whats the cold cranking rating? Had to replace mine because when it was under 30* it wouldn't start, replaced it with a diehard battery and it starts no matter what now (even if you leave the parking lights on over night *opps*.

check what the battery is putting out with...if its still 12V or not.
 

mob

the guy who hits on his mom
20+ Year Stangneter
Oct 3, 2003
2,566
136
104
Dallas, TX
Jan 2, 2008
#6
  • Jan 2, 2008
  • #6
Unfortunatly the car is at my friends house. Went to go try again and I think the battery is dead or something. Today was probably the coldest day of winter yet here. I tried jumping the relay but touching the two big terminals, it gave out a tiny tiny spark, and clicked once but nothing after that, I also jumped the small terminal and the battery terminal and it clicked and sparked alittle. When I put the key in it beeps really slow and eventually dies. When I try to turn it over it dies still.
 

stykthyn

I want to measure mine. It doesn't look that tall.
15 Year Member
Jul 6, 2006
5,232
2,652
223
gainesville
Jan 2, 2008
#7
  • Jan 2, 2008
  • #7
mine is doing the same thing. Florida is not supposed to be this cold
 

ryan218

In just 10 years, I'll be old enough to drive!!!!
Dec 28, 2005
0
1
38
columbus ohio
Jan 3, 2008
#8
  • Jan 3, 2008
  • #8
its 11* here right now in ohio.....im gonna have to let my stang warm up in the morning..i hate the cold....mod, try charging the battery overnight or just go pick up a nice duralast or diehard battery for around 60 bucks.
 

HISSIN50

"How long does it take to get help in here?
15 Year Member
Nov 29, 1999
31,179
34
129
Jan 3, 2008
#9
  • Jan 3, 2008
  • #9
As Ryan said, you need to charge the battery up or jump it before you can run Jrichker's checklist (any testing done right now has kinda been invalid).

Good luck.
 

04sleeper

Founding Member
Jun 22, 2002
2,674
14
89
Dallas, TX
Jan 3, 2008
#10
  • Jan 3, 2008
  • #10
One thing to add is how old is the battery? If it is less than 4 years old then I would look to see what caused it to die. (ie. alternator, wiring, underdrive pulleys etc...) You may get a new battery and it works for a while and then dies again if there is a problem.

I always "Double Check" the grounds if there was any kind of an issue, by actually disconnecting them and making sure everything is clean and then re-securing the grounds.
 

stykthyn

I want to measure mine. It doesn't look that tall.
15 Year Member
Jul 6, 2006
5,232
2,652
223
gainesville
Jan 3, 2008
#11
  • Jan 3, 2008
  • #11
screw duralast or diehard, I am going optima when I get a new battery
 

Jaswir

Member
Mar 31, 2005
578
0
18
Orlando, FL
Jan 3, 2008
#12
  • Jan 3, 2008
  • #12
sounds like battery is so old its not holding any kind of charge! And that short cold snap fried that bad boy!
 

mob

the guy who hits on his mom
20+ Year Stangneter
Oct 3, 2003
2,566
136
104
Dallas, TX
Jan 3, 2008
#13
  • Jan 3, 2008
  • #13
I work at advanced auto parts so I might be able to cop an optima, but if not Im just going to swap out the battery cause its from there. Thanks guys, ill let you guys know if that was the problem, just gotta wait for a ride now.
 

stykthyn

I want to measure mine. It doesn't look that tall.
15 Year Member
Jul 6, 2006
5,232
2,652
223
gainesville
Jan 3, 2008
#14
  • Jan 3, 2008
  • #14
wish I could cop an optima






something about that sounds ghey......................I still wish I could cop an optima
 

NKau

Founding Member
Dec 15, 2001
1,346
0
37
Jefferson, WI
Jan 3, 2008
#15
  • Jan 3, 2008
  • #15
You could always do some simple checks yourself. Take a voltmeter, and see what the battery reads as it sits, and what it reads when someone goes to crank the engine over. If you have 12v at rest, but a monster voltage drop when you go to start it, the battery is likely your trouble.
 

mob

the guy who hits on his mom
20+ Year Stangneter
Oct 3, 2003
2,566
136
104
Dallas, TX
Jan 3, 2008
#16
  • Jan 3, 2008
  • #16
Dont have a voltmeter. Battery just needed to be charged.
 

HISSIN50

"How long does it take to get help in here?
15 Year Member
Nov 29, 1999
31,179
34
129
Jan 3, 2008
#17
  • Jan 3, 2008
  • #17
mob said:
Dont have a voltmeter. Battery just needed to be charged.
Click to expand...

What will you do if there was an underlying issue, like your alt going out, and it drains the battery again?

I'd atleast have the system dynamically tested at the parts store.

Good luck.
 

mob

the guy who hits on his mom
20+ Year Stangneter
Oct 3, 2003
2,566
136
104
Dallas, TX
Jan 3, 2008
#18
  • Jan 3, 2008
  • #18
HISSIN50 said:
What will you do if there was an underlying issue, like your alt going out, and it drains the battery again?

I'd atleast have the system dynamically tested at the parts store.

Good luck.
Click to expand...

Alternator is new, battery was pretty old.
 
You must log in or register to reply here.

Similar threads

A
1987 5.0 speed density Foxbody crank no start
  • Alan2204
  • May 23, 2026
  • Fox 5.0 Mustang Tech
Replies
10
Views
595
Fox 5.0 Mustang Tech May 30, 2026
Mcmahst
Engine Surging idle on start-up
  • keel
  • Aug 11, 2025
  • Fox 5.0 Mustang Tech
Replies
16
Views
1K
Fox 5.0 Mustang Tech Oct 31, 2025
keel
B
Electrical Why does my fox body keep frying eecs
  • brandyn200
  • Jun 20, 2026
  • Fox 5.0 Mustang Tech
Replies
8
Views
523
Fox 5.0 Mustang Tech Jun 25, 2026
AeroCoupe
S
Need help asap
  • shaggyman65
  • Dec 24, 2025
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
2
Views
321
1996 - 2004 SN95 Mustang -General/Talk- Dec 24, 2025
shaggyman65
S
E
2007 GT Stalls when lights or a/c turned on
  • ejscarfo
  • Jun 22, 2026
  • 2005 - 2009 Specific Tech
Replies
3
Views
368
2005 - 2009 Specific Tech Sep 26, 2026
manicmechanic007
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?