• Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 V6 Mustang Tech

Need Help Diagnosing Knocking Noise

  • Thread starter Thread starter Cr-48
  • Start date Start date Nov 21, 2012
C

Cr-48

New Member
Nov 21, 2012
1
0
1
Nov 21, 2012
#1
  • Nov 21, 2012
  • #1
I need some help diagnosing a knocking noise from from motor, because I have no idea where to start. My car is a '97 with about 125,000 miles on it. There are two codes from the ECU, P1131 and P1151, which indicate lean readings from the upstream O2 sensors.

About two weeks ago I noticed my car started running rough when stopped at lights, there was a low rumbling/knocking noise and vibration. This would stop as soon as I shifted it to neutral, reverse, or park. The noise and vibration would also stop as soon as I let off the brake.

Around the same time, I accelerated pretty hard (~3k RPM) and heard a terrible knocking/clunking/bearing rattle noise and the car had very little power. I haven't pushed it that hard since then, but I can hear the noise starting when I get up past 2k RPM.

The problem has gotten worse, shifting it out of gear no longer stops the noise all the time. I can hear the noise now when accelerating from a stop and even cruising at around 1-1.5K RPM. I have also noticed it is worse when facing uphill. Rocking the car back and forward in park will also make it knock.

Any ideas at all are welcome. I have always done all the work on this car myself but I'm thinking I'll need to take it in after thanksgiving, because I don't know where to start trying to find the problem.
 

blacksheep-1

Member
Oct 21, 2006
322
4
18
Nov 30, 2012
#2
  • Nov 30, 2012
  • #2
So if you leave the car in drive and apply a small amount of gas pedal the noise really wakes up right? If so it's probably a bottom end knock, but first, pull each plug wire one at a time, with the engine running and see if the knock goes away. This could be something as simple as carbon bouncing around the combustion chamber, or a real issue. In any case remove (or ground) one wire at a time , if the noise shuts up it's in that cylinder.
 
Reactions: LWilson2971

kramer

Member
May 8, 2012
75
1
8
stonewall oklahoma
Dec 8, 2012
#3
  • Dec 8, 2012
  • #3
well heres what happened to me , i really dont know enough about engine internals , to really help u , but there is a slim chance that its an exaust leak right before the first cat on the passenger side , ford designed their air conditioners to drip rght there ON THE EXHAUST and it usually causes them to crack , or atleast mine did there was such a huge crack in mine that only about an inch and a half of metal was what was keepng it attached to the passenger manifold , and it sounded like a engine knock , infact a certified mechanic even diagnosed it as that and said id have to have it rebuilt , thank god i dont let mechanics work on my car or i would have done it , but in this case it probably is internally , but check it check it with a flash light its very hard to see in that particular spot
 

LWilson2971

New Member
Sep 18, 2012
12
2
1
Dec 14, 2012
#4
  • Dec 14, 2012
  • #4
Since you're getting the noise under load I'm guessing it's a rod knock. Put your foot on the brake and rev it slowly and only to about 1800 or so RPM's if the knocking gets worse then it's for sure in the bottom end and more then likely a rod. With it continuing to get worse and you stated it does it worse going uphill ( again under load ) I'm about 95% sure you have a rod knock. I wouldn't travel to far from home if I were you and go easy on it because you don't want it coming apart at 5k RPMs
 
T

Tyler Neuman

New Member
Aug 27, 2015
12
0
1
Aug 31, 2015
#5
  • Aug 31, 2015
  • #5
blacksheep-1 said:
So if you leave the car in drive and apply a small amount of gas pedal the noise really wakes up right? If so it's probably a bottom end knock, but first, pull each plug wire one at a time, with the engine running and see if the knock goes away. This could be something as simple as carbon bouncing around the combustion chamber, or a real issue. In any case remove (or ground) one wire at a time , if the noise shuts up it's in that cylinder.
Click to expand...

What if when you unplug the cylinder the knocking gets louder?
 
You must log in or register to reply here.

Similar threads

B
Engine Strange Noise
  • burntokita
  • May 8, 2026
  • Fox 5.0 Mustang Tech
Replies
8
Views
408
Fox 5.0 Mustang Tech May 11, 2026
keel
U
8 Years of Vibration leading to engine knock?
  • UpgradeXP
  • Apr 14, 2025
  • SN95 V6 Mustang Tech
Replies
3
Views
471
SN95 V6 Mustang Tech Apr 14, 2025
Noobz347
S
08 Mustang gt high pitched noise from rear
  • sainto
  • Jun 30, 2025
  • 2005 - 2014 S-197 Mustang -General/Talk-
Replies
0
Views
241
2005 - 2014 S-197 Mustang -General/Talk- Jun 30, 2025
sainto
S
A
Rough idle - cylinder 1 and 6 misfire HELP
  • austindavies935
  • Jul 24, 2025
  • SN95 4.6L Mustang Tech
Replies
12
Views
738
SN95 4.6L Mustang Tech Jul 24, 2025
gkomo
Ford truck engine swap issues
  • keel
  • Jul 7, 2026
  • Other Auto Tech
Replies
17
Views
321
Other Auto Tech Jul 13, 2026
General karthief
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 V6 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?