anyways ive been installing my LT's have the k member dropped (and old headers out) and the engine being held by a floor jack (under the main part of the oil pan) w/ a 2x4 across it along with a straight jack with another 2x4 across the front of the oil pan anyways to make a long story straight i lowered the engine about 2-3 inches so i could access the nuts on the passenger side header anyways i noticed that part of the frame is running into the LT on this side and it appears that the engine has shifted more to the left side of the car.... which to me i see as a pretty big issue its sitting fine on the jacks and not once did i notice any movement in it at all but i can tell its def. off how do i go about getting the engine re-aligned with the car so i can finish this *****
by the way the car is on two ramps in the rear and 2 jackstands in the front with 2 more jackstands for backup right now im regreting doing the install my self if i was too do this again i would prob pay a shop too do it
by the way the car is on two ramps in the rear and 2 jackstands in the front with 2 more jackstands for backup right now im regreting doing the install my self if i was too do this again i would prob pay a shop too do it