NEED HELP W/ NEW UPGRADES!

CobraSVT95 · Jul 20, 2004

Well guys thanks for looking

heres the thing i am getting ready to install all of the items listed...

Eddy Performer 5.0 upper lower intake
BBK 70mm TB
BBK UD Pulleys
BBK CAI
Pro M 75mm MAF
Ford 24lb Fuel Injectors
Steeda Tri Ax Shifter
Ford 8.8 3.73 gears

but the problem is i am not the one installing all this stuff and when my friend/ford mechanic i want to make sure i have EVERYTHING he needs to complete the job, like any gaskets, sealants, special tools or anything else he probably wont have with him.

thanks

CobraSVT95 · Jul 20, 2004

i guess i will also need:

intake adapter for TB
new shift knob
boot
and for gears a crush collar
new pinion bearing
pinion nut

please feel free to correct anything you see

mo_dingo · Jul 20, 2004

Here are some of the things off the top of my head.

Gaskets for the intake manifold. I can't remember if there is one between the upper/lower. Someone here can post further on this; As I remember RTV being mentioned, but I am not sure if it can be used all the way around.

New gasket for the TB to intake plenum.
Access to air tools for the u/d pullies.
New o-rings for the injectors (unless they have new ones)

As for the gears, I made a thread w/ a list of everything that I bought for the install. Some things I didn't use, but I just wanted to have them on hand in case I had a problem (i.e. carrier/pinion bearings).

Here it is. Also, here is a link to things that came up that were slightly unexpected & might help you out.

I can't think of anything else. Good luck!
Scott

CobraSVT95 · Jul 20, 2004

"RTV"?

AznStanger3v · Jul 20, 2004

CobraSVT95 said:
"RTV"?

silicone gasket maker.

youll need the gaskets from:
-the lower plenum to the heads
-thermostat gasket
-TB to elbow (shouldve come with tb)
-EGR gasket to elbow
-Elbow to upper plenum

Maybe invest in new PCV valve, new vacuum hoses, etc.

AznStanger3v · Jul 20, 2004

oh, and to make life easier for your buddy, get a rear end overhaul kit that way there is no need to go searching for the parts for the gear install. You dont NEED a new shift knob either.

CobraSVT95 · Jul 21, 2004

thanks for all the info "mo" and "17yrOldStanger"

i guess i will also after do a tune up too:

performance wires, cap and rotor, spark plugs, etc...

NEED HELP W/ NEW UPGRADES!

CobraSVT95

New Member

CobraSVT95

New Member

mo_dingo

CobraSVT95

New Member

AznStanger3v

Active Member

AznStanger3v

Active Member

CobraSVT95

New Member

Similar threads

NEED HELP W/ NEW UPGRADES!

CobraSVT95

New Member

CobraSVT95

New Member

mo_dingo

CobraSVT95

New Member

AznStanger3v

Active Member

AznStanger3v

Active Member

CobraSVT95

New Member

Similar threads

Privacy & Transparency

Privacy & Transparency