My thermostat fan controller keeps blowing fuses.if I put a paper clip in the holder the fan will run but the fuse holder gets hot.the fan controller has a relay that plugs into it.The controller works and cycles the fan off and on . the fan works good when it is running and it is extremely quiet.Is there a way to check the fan with a voltmeter to see if it is drawing too much current?the way this controller is wired there is red wire going directly to the battery,there is an orange wire that is fused with a 25 amp fuse that goes to the fan,there is a black ground wire,there is a green wire that goes to the A/C switch,and a yellow wire that goes to constant 12v.I used heavy gauge wire on the red and the orange wire figuring that would minimize resistance, is that a possible problem?