Need internal parts for 1964 Eaton power steering pump

[gregp1962]

The input shaft on this Eaton pump is hammered. I can't find an input shaft in any catalogs anywhere. Any ideas?

 

[tweet66]

If the pump is the same, I have a working unit from my 6cyl Falcon lying around, if your interested. I have no plans on using it.

 

[gregp1962]

Does anoyone have or know where I can get an input shaft for an Eaton power steering pump?

 

[5.0ina66]

Contact randy at stangerssite.com

 

[5.0ina66]

teh double post FTL

 

[gregp1962]

OK, does anyone know how the cam ring goes in? There is a notch on one side of it. But, I can't see how that orients it.

 

[stanger53]

The notch does orient the cam ring because there is a small pin that fits in a hole drilled at an angle at the bottom of the recess for the cam ring in the housing.

A small pin that it is easy to miss if you don't know it's there and will just as easily fal out and get lost.

 

[gregp1962]

OK, I can't find the pin that holds the cam ring in place. I have a rebuild kit. but, it doesn't include that pin. Does anyone know where I can get one?

Also, I'm assuming that the cam ring fits with the notch down in the front half of the housing.