• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

Need serious help

  • Thread starter Thread starter 87_stang
  • Start date Start date Feb 8, 2007

87_stang

Member
Dec 12, 2005
131
0
16
Tonganoxie, KS
Feb 8, 2007
#1
  • Feb 8, 2007
  • #1
If it aint one problem its another. OK heres the deal, I just got my idle problem taken care of I think. I just got the car Saturday and while out taking my cousin for a ride earlier I punched it in first and then hit second, pedal to the floor and it fell on its face. I mean when hit second and poped the clutch/hit the gas, nothing happened for about 2-3 seconds, I let off the gas and slowly got back on the gas and it then revved up about 2-3 seconds later. I have never had this happen in any of my other stangs so I dont got a clue what it is. Any ideas are appreciated. I was so excited too while we were just cruising around and of all thing I loved the stop signs cause it finally would idle and not die or surge on me but then got discouraged when the car fell on its face as bad as it did.
 

eagleautosports

New Member
Jul 7, 2006
139
0
0
Mebane NC
Feb 8, 2007
#2
  • Feb 8, 2007
  • #2
I'd say check the TPS sensor. Without this one working right, you're up the creek. If it was me, I'd go ahead and replace it.
 

87_stang

Member
Dec 12, 2005
131
0
16
Tonganoxie, KS
Feb 9, 2007
#3
  • Feb 9, 2007
  • #3
I got on Summit Racing and looked at the tps's on there and they only show one for a 1991-1993 5.0 Mustang, why is that? And could a bad tps be my problem if it is not turning on my check engine light? I thought maybe the previous owner may have disconnected the light but it comes on while the key is on/engine is off so I know it works. I just know the car has hesitation when punching the gas and it was horrible last night. I hit the gas after going into 2nd and it would not rev up at all for about 2-3 seconds and I let off and eased into it. Thank you guys, I really appreciate the help.
Brandon
 

HISSIN50

"How long does it take to get help in here?
15 Year Member
Nov 29, 1999
31,179
34
129
Feb 9, 2007
#4
  • Feb 9, 2007
  • #4
Is your clutch slipping?
 

87_stang

Member
Dec 12, 2005
131
0
16
Tonganoxie, KS
Feb 9, 2007
#5
  • Feb 9, 2007
  • #5
No, clutch is fine. I mean it wouldn't even rev up, just like I didn't even touch the throttle. Any ideas?
 

Mustang78

New Member
Feb 8, 2006
486
0
0
Aberdeen, WA
Feb 9, 2007
#6
  • Feb 9, 2007
  • #6
check air cleaner/hoses, and put gas in it!

~Mark~
 

87_stang

Member
Dec 12, 2005
131
0
16
Tonganoxie, KS
Feb 9, 2007
#7
  • Feb 9, 2007
  • #7
lol, it has a full tank! I checked the air cleaner and it looks great, it is a brand new K&N filter. After reading the above, does it still sound like a bad tps to anyone else? I want to get a few more opinions before I just go out and start buying parts to throw at it.
 

HISSIN50

"How long does it take to get help in here?
15 Year Member
Nov 29, 1999
31,179
34
129
Feb 10, 2007
#8
  • Feb 10, 2007
  • #8
You only noted an issue in 1st and second gear - if it's fine in all other gears, that would kind of rule out the TPS (though it's easy enough to test. An analog meter works best for testing it).

If you haven't, pull codes.

Good luck.
 

87_stang

Member
Dec 12, 2005
131
0
16
Tonganoxie, KS
Feb 10, 2007
#9
  • Feb 10, 2007
  • #9
OK, I have notice if I punch the gas a little it will have a hesitation at first, and also 3rd/4th gear doesn't have the response/acceleration like it should.
 

302RollinHard

New Member
Sep 26, 2005
0
0
0
Columbus, OH
Feb 10, 2007
#10
  • Feb 10, 2007
  • #10
I would first check the TPS and then change the fuel filter. They tps should be around .97 volts at idle and have a smooth linear increase in voltage up to wide open throttle which should be in the 4.5-4.8 volts ballpark. Also monitor fuel pressure under load, could be fuel pump.
 
S

superhuaman

New Member
Nov 8, 2004
907
0
0
Harrisburg, PA
Feb 10, 2007
#11
  • Feb 10, 2007
  • #11
yeah...you dont punch the throttle in other gears like you do in 1st and 2nd, so you wont notice THAT problem in other gears. but it hesitates in other gears too...so it could very well be the tps. check for codes!

i was told to repair my fuel injector harness. there is a clamped (not soldered ) splice in the harness which is power for only the tps and the evp (egr valve position). if it gets hot it may fail and give you a high idle, check engine light, hesitation, or all three. if you have a high idle and you shut off and restart and it comes back, its usually a vacuum leak or the iac. if it doesnt come back, its usually the tps.

i know, more than you asked for, right?
 
You must log in or register to reply here.

Similar threads

D
rpm goes up - car does not speed up.
  • dawakbar
  • Oct 26, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
3
Views
161
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Oct 27, 2026
nickyb
93 LX 5.0 - 2,000 rpm misfiring, stuttering, and bogging upon acceleration (videos)
  • dan50
  • Nov 14, 2026
  • Fox 5.0 Mustang Tech
Replies
5
Views
128
Fox 5.0 Mustang Tech Nov 15, 2026
General karthief
C
Engine Idle cuts out
  • claypoolxx
  • Mar 7, 2026
  • Fox 5.0 Mustang Tech
  • 2
Replies
25
Views
1K
Fox 5.0 Mustang Tech Jul 24, 2026
alutwon
K
Resolved Need some assistance. Holley Terminator X alongside H/C/I. Very rough/inconsistent idle
  • karhoot
  • Jun 6, 2026
  • Fox 5.0 Mustang Tech
Replies
0
Views
240
Fox 5.0 Mustang Tech Jun 6, 2026
karhoot
K
9
Electrical F150 ECU in a Foxbody? Idle surge help
  • 93royalblue
  • Sep 10, 2025
  • Fox 5.0 Mustang Tech
Replies
6
Views
577
Fox 5.0 Mustang Tech Sep 17, 2025
Mustang5L5
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?