Howdy! I have done some searching and reading, but have not come up with a definitive answer. I am getting ready to do an intake and MAF conversion on my '87 and wanted to dress up a bit by adding valve covers. In reading, I understand that there are some issues with clearance on EFI cars. If anyone could give me some sound advice on what type and brand covers to use, I would greatly appreciate it. I really like the FMS crinkle finish that have "Mustang - Powered by Ford" on them. Here is what I am changing on the car:
MAF conversion
UPR CAI
GT-40 intake
The car already has a strut tower brace. This has caused quite a few problems by itself! I had to trim the stock plastic oil filler cap down so that I could get it out from under the brace and changing the cap and wires is almost a job for the Great Houdini!! Thanks in advance for any advice that you guys or gals may have!
Barry
MAF conversion
UPR CAI
GT-40 intake
The car already has a strut tower brace. This has caused quite a few problems by itself! I had to trim the stock plastic oil filler cap down so that I could get it out from under the brace and changing the cap and wires is almost a job for the Great Houdini!! Thanks in advance for any advice that you guys or gals may have!
Barry