• Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech

Need some Help!

  • Thread starter Thread starter caffinecobra
  • Start date Start date Mar 19, 2004

caffinecobra

New Member
Mar 19, 2004
61
0
0
Sacramento, CA
Mar 19, 2004
#1
  • Mar 19, 2004
  • #1
I just had my gears installed and chipped to compensate the speedo. Drives excellent and I *love* the change! All of a sudden last night I was on the frwy and the car just died. It seemed as the the computer just shut down. The car was still idleing fine, but all of the gauges shut down and the odometer displayed a bunch of dashes "- - - - - - - - -". I was in gear and there was no throttle and I lost power steering, brakes, and alternator (the lights began to dim). I pulled into the slow lane, killed the ignition, turned it back on, and pop started it and it went back to normal for about 3-5 minutes then did it again. By the time I got home it was cycling about every 10 seconds. This morning I called the shop and they said to bring it in. I decided that it must have something to do with the computer so I pulled it out, re-seated the chip, and re-taped it. (it was duct taped on?) I stuffed the computer back into the kick panel and drove to work (about 18 miles) with no problems at all.

Has anyone seen anything like this before? The chip didn't seem to be loose when I reseated it. I'm going to bring it in and have it looked at but I was curious if anyone had any suggestions or ideas.

Thanks!
 

caffinecobra

New Member
Mar 19, 2004
61
0
0
Sacramento, CA
Mar 21, 2004
#2
  • Mar 21, 2004
  • #2
It appears to have been either dirty contacts on the chip/board or a loose chip. Had the contacts cleaned and the chip taped in better and haven't had a problem since.
 
You must log in or register to reply here.

Similar threads

L
2000 Mustang PATS - Broken Key and Wire - HELP!
  • Laree Taylor
  • May 7, 2026
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
10
Views
111
1996 - 2004 SN95 Mustang -General/Talk- May 12, 2026
manicmechanic007
K
Electrical 2000 GT Intermittent Engine Shutdown In Motion - DTC U1262
  • kenster1092
  • Apr 13, 2026
  • SN95 4.6L Mustang Tech
Replies
4
Views
128
SN95 4.6L Mustang Tech Apr 24, 2026
squeak93
T
Greetings from a guy who needs help with a foxbody.
  • thefonztm
  • Mar 21, 2026
  • The Welcome Wagon
Replies
16
Views
367
The Welcome Wagon Mar 22, 2026
Noobz347
C
C4 trans help needed
  • CPH89LX
  • Apr 26, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
6
Views
132
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Apr 28, 2026
CPH89LX
C
M
Need help!
  • Masonevans726
  • Dec 17, 2025
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
1
Views
207
1996 - 2004 SN95 Mustang -General/Talk- Dec 17, 2025
Masonevans726
M
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?