Hey guys, I just bought some brand new hood hinges and hood springs for my 67 Cougar XR7. When I put on the hinges (without the springs) and tried to open the hood I had to squat down and leg press the dang thing open. I was afraid I was going to bend the hinges or hood or something. The hood was popping and cracking and flexing; that's how much force that has to be used. When I closed it, it wasn't so bad but it was still real stiff and took a little effort to close it.
So then I put the new hood springs on the hinges and when I opened the hood it opened fairly easy (about as easy as it did when it closed without the hood hinges installed). But when I tried to close the hood I practically had to hang on the hood with my feet off the ground and use my weight and gravity to get it closed (I weigh 195 lbs). And once I did get it closed, the back of the hood was standing about 3" to 4" above the cowl. It would not close flush with the cowl whatsoever. I had to practically sit on the hood to get it to go down and it still wouldn't go down far enough to be flush with the cowl. It still stood about 1" above the cowl.
Something isn't right. I know these hinges are new, but I can't believe it should be this difficult to open and close the hood. I guarentee a female would be lucky to get it close without having some help or getting on top of the hood and jumping up and down on it.
Is there anything I can do to loosen up these hinges and make them open and close easy like they should? Is there some sort of break in process I'm not aware of? Any advise would be greatly appreciated....
So then I put the new hood springs on the hinges and when I opened the hood it opened fairly easy (about as easy as it did when it closed without the hood hinges installed). But when I tried to close the hood I practically had to hang on the hood with my feet off the ground and use my weight and gravity to get it closed (I weigh 195 lbs). And once I did get it closed, the back of the hood was standing about 3" to 4" above the cowl. It would not close flush with the cowl whatsoever. I had to practically sit on the hood to get it to go down and it still wouldn't go down far enough to be flush with the cowl. It still stood about 1" above the cowl.
Something isn't right. I know these hinges are new, but I can't believe it should be this difficult to open and close the hood. I guarentee a female would be lucky to get it close without having some help or getting on top of the hood and jumping up and down on it.
Is there anything I can do to loosen up these hinges and make them open and close easy like they should? Is there some sort of break in process I'm not aware of? Any advise would be greatly appreciated....