New motor and no spark

[Swade214]

I have finally got my new 347 in my 69 mustang. I have a painless harness with a A9L computer. The distributer went with the motor but was speed density. Will this work on mass air? Have power at the new coil. Car will turn over and fuel pump runs. This distributer worked before the rebuild.
Thanks

 

[-86GTStang]

Check the Ignition module and wires, located on the distr. Its no diff. between Mass air/speed dens. setup regarding the distr.

 

[HISSIN50]

Also toss a noid light on an injector and see if it is pulsing. Assuming proper 12 volts to the injectors and that the wiring is right, if you dont have spark and injector pulsing, that suggests the PIP is not up to par.

If only no spark (but you do have injector firing) that suggests the PIP is good to go and that it is the TFI, coil, etc, as was mentioned.

Good luck - sounds like a cool swap.