New times from the track

I was in Ohio on Thompson drag raceway today and I race little bit ( like 14 runs ) and gues what I have better time that last year but I have more mods that last year ) LTs,Pro 5.0 Shifter,Nitto DRs, UCA/LCA, Ported U/L 95 Cobra intake, Kirban Billet Adjustable Fuel Presure Regulator, Walbro 255lph HP, MSD 6A Ignition,Blaster High Vibration Coil , here is my time ,still bad BUT better than before

60ft 2.11
1/8 9.505@??
1/4 14.79@92.90

my old the best time was

60ft 2.32
1/8 9.70@??
1/4 14.89@93

I know this is still bad tim but weater was bad , 45 F too cold ,Nittos couldn't can do better , but I have bad driveshaft ( balance is off and vibrations on higher speed 80mph +) and tranny maunt is bad too
But I still thinkin something else is wrong , LOW end torque , because when I installed ported U/L 95 Cobra intake I fell that low end is gone , it's more like 4K and up , before if I driving is 2nd on low rpms like 2k and hit gas car gonna move quickly but now it's like dog until reach 3K , meybe something else is bad , meybe ignition or something , I check evetything , no vacum leak, no fuel leak no any kinda leak, plugs are gray , fuel pressure is 39psi with vaccum like attached , but still no low end torque
Here is my other post about "bad" ingition http://forums.stangnet.com/showthread.php?t=450200
PLZ give me your opinions

Here is some mine videos from the track

Me vs 95 SC T-Bird

Me vs 94 Mustang GT with gears and cat back

Me vs LT1 T/A

BS , I run f***** slow ,
Yes WOT all the time , you can heard my exhaust better because wind are strong
and yes that sunfire lose realy bad like , i don't know 20 cars he run 18.1 and he is my friend from club " ErieSpeed .com "

I have a few more video but I have to put on server , but soon I'll post them