What’s up,
I have a 91 LX 5.0, a ZEX kit and a MSD digital 6. Having some problems too. Everything is installed including the purge kit but there are two wires I don’t really know where to put. One is the 12 volt for the MSD it’s supposed to go to the ignition switch I believe and the other is the arming switch for the ZEX kit. The instructions don’t really make it clear as to how it goes so I figured I’d ask you guys on the forum. The arm switch for the juice doesn’t engage it either it just arms it. WOT engages it and that is wired correctly. The Zex kit is not getting power at the arming switch and the MSD is getting power from the battery. I thought if I used the 12 volt from the MSD and spliced it to the ZEX kit and then ran a connector to the arm switch it would get power when I turn the key "ON" and the arm switch “ON”, But it doesn’t. As of now it is disconnected. Any suggestions besides call a professional?
I have a 91 LX 5.0, a ZEX kit and a MSD digital 6. Having some problems too. Everything is installed including the purge kit but there are two wires I don’t really know where to put. One is the 12 volt for the MSD it’s supposed to go to the ignition switch I believe and the other is the arming switch for the ZEX kit. The instructions don’t really make it clear as to how it goes so I figured I’d ask you guys on the forum. The arm switch for the juice doesn’t engage it either it just arms it. WOT engages it and that is wired correctly. The Zex kit is not getting power at the arming switch and the MSD is getting power from the battery. I thought if I used the 12 volt from the MSD and spliced it to the ZEX kit and then ran a connector to the arm switch it would get power when I turn the key "ON" and the arm switch “ON”, But it doesn’t. As of now it is disconnected. Any suggestions besides call a professional?