• Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech

No Oil Pressure Until Engine Warm (GT)

  • Thread starter Thread starter StangVert00
  • Start date Start date Nov 3, 2004

StangVert00

New Member
Mar 2, 2003
234
0
0
Stoneham, MA
Nov 3, 2004
#1
  • Nov 3, 2004
  • #1
Greetings,
I own a '00 GT 'Vert.
When the car is cold, and I start the engine, I get no oil pressure from the gauge until the engine reaches normal temp. (warms up)
After about 2 mins, the oil pressure gauge will go from zero to mid range for a few seconds, then drop down to zero (far left reading) then back to mid range.
This goes back and forth until the engine is warmed up. (after about 5 minutes)
Once the engine is warmed up, if I turn the ignition off and restart the car, the oil pressure is fine. (at mid range)
I checked the amount oil the engine has, and it is fine.
No mods have been made on my car other than an K&N air filter.
I get no "Idiot Lights" when this is happening. All other gauges seem to be OK.
Faulty gauge? Bad voltage regulation to the gauge? Oil pump going?
Any ideas come to mind? Has this happened before to any of you?

Thanks in advance,
StangVert00
 
R

raykrv6a

New Member
Sep 7, 2004
153
0
0
Maple Grove, MN
Nov 3, 2004
#2
  • Nov 3, 2004
  • #2
StangVert00 said:
Greetings,
I own a '00 GT 'Vert.
When the car is cold, and I start the engine, I get no oil pressure from the gauge until the engine reaches normal temp. (warms up)
After about 2 mins, the oil pressure gauge will go from zero to mid range for a few seconds, then drop down to zero (far left reading) then back to mid range.
This goes back and forth until the engine is warmed up. (after about 5 minutes)
Once the engine is warmed up, if I turn the ignition off and restart the car, the oil pressure is fine. (at mid range)
I checked the amount oil the engine has, and it is fine.
No mods have been made on my car other than an K&N air filter.
I get no "Idiot Lights" when this is happening. All other gauges seem to be OK.
Faulty gauge? Bad voltage regulation to the gauge? Oil pump going?
Any ideas come to mind? Has this happened before to any of you?

Thanks in advance,
StangVert00
Click to expand...

The oil gauge is just driven by on or off. It really doesn't register the oil pressure.

Loose connection, bad on/off sending unit?
 

Premium Speed

New Member
Apr 22, 2003
1,006
0
0
Houston, Texas
Nov 4, 2004
#3
  • Nov 4, 2004
  • #3
replace the oil pressure sending unit...
 

StangVert00

New Member
Mar 2, 2003
234
0
0
Stoneham, MA
Nov 4, 2004
#4
  • Nov 4, 2004
  • #4
Premium Speed said:
replace the oil pressure sending unit...
Click to expand...

Ahhh! Thanks much for the advice!

I just hope that it's only the sending unit!

Thanks again!

StangVert00
 

RTRMustangGT

New Member
Sep 30, 2004
43
0
0
Nov 4, 2004
#5
  • Nov 4, 2004
  • #5
You don't know how crappy the stock gauges are until you put an after market gauge on your car. I put an autometer oil pressure gauge on my car on the a-pillar and it is a lot more accurate than the factory on. like it was said before, the factory gauge is either completely off or it is straight up reading fine. it does not fuctuate any. it sounds to me like a loose conection or a bad sending unit. the sending unit is right underneath the oil filter if you want to check it out for a loose connection. try unluging it and pluggin back in a few times.


 
You must log in or register to reply here.

Similar threads

C
98 gt fuel pressure issues
  • chasecollier1984
  • Jun 2, 2026
  • SN95 4.6L Mustang Tech
Replies
0
Views
71
SN95 4.6L Mustang Tech Jun 2, 2026
chasecollier1984
C
Electrical Issues with my 2006 mustang gt
  • VerneVdV
  • May 22, 2026
  • 2005 - 2009 Specific Tech
Replies
0
Views
81
2005 - 2009 Specific Tech May 22, 2026
VerneVdV
M
warmed up, hard re-starting on hot days
  • michaelleewebb
  • Mar 26, 2026
  • SN95 V6 Mustang Tech
Replies
9
Views
267
SN95 V6 Mustang Tech Mar 29, 2026
michaelleewebb
M
M
01 mustang 3.8 fuel pressure issue
  • Mhaley2006
  • May 29, 2026
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
0
Views
133
1996 - 2004 SN95 Mustang -General/Talk- May 29, 2026
Mhaley2006
M
A
Rough idle - cylinder 1 and 6 misfire HELP
  • austindavies935
  • Jul 24, 2025
  • SN95 4.6L Mustang Tech
Replies
12
Views
703
SN95 4.6L Mustang Tech Jul 24, 2025
gkomo
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?