Noise when going over small road irregularities

Since your car is lowered, does it look like your outer tie rods are in a bind? Have you replaced your ball joints? What does the noise sound like?

put the front of the car on jacks and inspect under. look at the U joints, and move your tires around there should be no play. if there is it could be your tie rods or bearings.

If it's not DS scoring, I'd check motor/trans mounts, crossmember mounts and consider that the DS is trying to slide longitudinally in the tailshaft while the suspension articulates.

Good luck.

9 Deuce GT said:

Thanks for the reply guys. This last comment is around the area of the vehicle that I think the noise is coming from. It is sort of like a bearing/rotational type noise. Like something is spinning and out of alignment. I have noticed the trans moves alot over bumps. I have been thinking about changing the trans mount, but have just been lazy. I will look into this.

Hissin50, is there any type of scoring or markings that I can look for if what you are describing is the problem?

Click to expand...

Good call on the trans and Crossmember mounts. Poly versions can be had for about 50 bucks; parts store versions are less.

If you look at the DS, you might see a line around it somewhere. I had it with my old school 2 chambers (the big rectangular ones). If your DS is clean and you can see anything, a light coat of contrasting spray paint (black on an alum DS; white on a stocker) in the areas where there is parts close to the DS can help see where it touches (like near the parking brake bracket, near mufflers if they're close to the DS, etc).

Alum DS's are larger in diameter than the stocker, and folks have been known to rub a good channel into the DS because of this.

Good luck.