• Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech

Official Tremec 3650 Issues Thread

  • Thread starter Thread starter Twisted
  • Start date Start date May 27, 2003
Prev
  • 1
  • …
  • 6
  • 7
  • 8
  • 9
  • 10
  • …
  • 92
Next
First Prev 8 of 92 Next Last

LaserPony02

Founding Member
Dec 2, 2001
88
1
9
Bridgeport Connecticut
Jun 16, 2003
#141
  • Jun 16, 2003
  • #141
Originally posted by 20BlackGT02
I have the same exact problems you do! I'm starting to think this sh^t is normal if a lot of people are experiencing the same problems.
Click to expand...

There is some slack inherent in the driveline. The clunk you are hearing from the rear is most likely the driveshaft moving a bit. Nothing to worry about. Good luck with your trans. I have zero problems with mine and I live in a cold weather climate. Car is a daily driver.
 

Black1998GT

Founding Member
Jun 26, 2001
4,427
0
0
Swannanoa, NC
Jun 16, 2003
#142
  • Jun 16, 2003
  • #142
how about a lawsuit including the t-45?
 
K

Kobramorder

New Member
Apr 22, 2003
102
0
0
Jun 17, 2003
#143
  • Jun 17, 2003
  • #143
How much trouble are the auto guys having? The last auto I had was a '89 2.3L with AOD, and the tranny barely held up to that! I had to have it rebuilt at 90,000 miles. My friends '90 5.0 went thru at least 4 AOD's between '90 and '93. I don't know anything about the whatever it is, 470R something other? I don't know of any T-45's with problems. One of my cousins "crew" has a 99 GT with 120,000 miles of hard abuse, never serviced the rear end, tranny, brakes, etc. and had it's last oil change at 90,000 miles. It is stock with an h-pipe, and stock springs chopped off by 2 1/2 coils. No power adders. In first, floor from any speed and it spins, hits 150 in fourth, and can top it in 5th. The speedo was past the 150 mark. He stills runs 13.9-14.0's. No other GT I have drove will do this. I don't think he has gears, but if he does, we didn't put them in. Go figure. I guess some Mustangs are better made than others. Or, abused cars run better?
 

Miklowcic

Active Member
Apr 24, 2001
2,432
0
47
Hillsborough, NJ
Jun 17, 2003
#144
  • Jun 17, 2003
  • #144
hmmmm

I had that 1 to 2nd bump in my 01 gt, but I also have the same bump in my T56 in my 03 cobra. When I rev it high it shifts smoothly, but on the street shifting normally, it is not smooth at all.

My 01 gt was the same. When i shifted at 3000+ rpms it would go in smooth, but lower revs and it would bump into gear. My Dad drove the car and thought it was just because it was so new and needed to be broken in. It never got any better though.
 

NUKEPLANT

Founding Member
Apr 9, 2000
202
0
0
NEPA
Jun 17, 2003
#145
  • Jun 17, 2003
  • #145
I don't know. Begining of May my car had 7000 miles(sat all winter), now i have 9400. These last 2400 miles i have beat the he!! out of the car. I don't understand it but the car is running better than ever.
 

4.6MustangSteve

New Member
Jun 13, 2003
219
0
0
Northern VA, USA
Jun 17, 2003
#146
  • Jun 17, 2003
  • #146
I have noticed that when I'm hard on the car I don't have any clunking or grinding, its very smooth. Kinda wierd.
 
H

highoctane46

New Member
Jun 18, 2003
27
0
0
North Carolina
Jun 18, 2003
#147
  • Jun 18, 2003
  • #147
Mine has about 3500 miles on it and it has had a distinct third gear whine(gear noise) since about 100 miles, dealer added an additive and said "If that don't fix it we'll put in a new tranny"
 
Z

Zate

New Member
Jun 19, 2003
2
0
0
Tampa FL
Jun 19, 2003
#148
  • Jun 19, 2003
  • #148
Zate Berg 2003 Mach 1 5500 miles

had the 1-2 issue since day 1.. and car wont go into 3rd at high RPMs quite often.
 

1wildGT

Founding Member
Jun 4, 2001
1,026
6
38
Abilene TX
Jun 19, 2003
#149
  • Jun 19, 2003
  • #149
Mine is notchy on the 1-2 shift when the car isn't fully warm, but once it is warm no problems regardless of outside temp. I don't powershift my stang when it's cold anyways so it is a non-issue for me. I don't want the dealer screwing it up worse.
 
G

Golions

New Member
Jun 8, 2003
60
0
0
Jun 19, 2003
#150
  • Jun 19, 2003
  • #150
I haven't had any problems with mine yet, thankfully. I have heard a clunk, 1-2, only when I push it hard and pop the clutch quickly. As long as the clutch is eased into gear properly I am fine. No troubles hitting 3rd at any RPM. Never had a problem with reverse.

GiddyUp!

 
E

ed0202

New Member
Jun 19, 2003
1
0
0
Baltimore
Jun 19, 2003
#151
  • Jun 19, 2003
  • #151
I have it

I love the Bullitt but hate the tranny. Bullitt #1935 has the problems.
 

trinity_gt

10 Year Member
Jan 31, 2003
3,125
81
99
Canada
Jun 19, 2003
#152
  • Jun 19, 2003
  • #152
Went for a test-drive yesterday in a 2003 MGT with 60-miles on the clock (it turned 100-kms during the test drive...) and noticed a definite grind going into 2nd. Does it usually manifest itself so early in the life of the car or is this "normal" and the real problem will get much worse later?
 

4.6MustangSteve

New Member
Jun 13, 2003
219
0
0
Northern VA, USA
Jun 19, 2003
#153
  • Jun 19, 2003
  • #153
Well, I got my car with about 60 miles on it and when it's just started up there is a clunk and occaisionally a grind when going into 2nd gear. The grind was very subtle though and nothing very big. You could hear and feel the clunk when going 1-2. It just had a feel of reluctancy to engage that gear.

I have about 1400 miles on the car now and I don't notice it getting any worse. When I start the car I shift slow and smooth until it warms up. When I do this it doesn't clunk as bad and I havn't noticed any grinds lately.
 

funk

Founding Member
Jul 14, 2002
614
0
16
Houston,TX
Jun 20, 2003
#154
  • Jun 20, 2003
  • #154
I would sometimes have the 1st to 2nd problem. But I took it in today to have it look at for 4th gear. It would grind bad going into 4th. They called me back yesterday and said that they are replacing the transmission.
 
T

The Rock 326

New Member
Jun 9, 2003
21
0
0
AL
Jun 21, 2003
#155
  • Jun 21, 2003
  • #155
tranny

I guess that I should have read this before I posted my? I bought my 02 with 8800K and noticed the grind between 1&2. I have heard a rumor that there is going to be a recall either from Ford or Tremec in the near future.
 

4.6MustangSteve

New Member
Jun 13, 2003
219
0
0
Northern VA, USA
Jun 22, 2003
#156
  • Jun 22, 2003
  • #156
i sure hope they have a recall soon.
 
W

wulffy

New Member
Dec 3, 2002
24
0
0
south jersey
Jun 23, 2003
#157
  • Jun 23, 2003
  • #157
Anyone else hear about this recall? Is there any fact to this? Where did this information come from? I am curious to know what they plan on doing.
 
W

wulffy

New Member
Dec 3, 2002
24
0
0
south jersey
Jun 23, 2003
#158
  • Jun 23, 2003
  • #158
Anyone else hear about this recall? Is there any fact to this? Where did this information come from? I am curious to know what they plan on doing.
 
W

wulffy

New Member
Dec 3, 2002
24
0
0
south jersey
Jun 23, 2003
#159
  • Jun 23, 2003
  • #159
Anyone else hear about this recall? Is there any fact to this? Where did this information come from? I am curious to know what they plan on doing.
 
W

wulffy

New Member
Dec 3, 2002
24
0
0
south jersey
Jun 23, 2003
#160
  • Jun 23, 2003
  • #160
Anyone else hear about this recall? Is there any fact to this? Where did this information come from? I am curious to know what they plan on doing.
 
Prev
  • 1
  • …
  • 6
  • 7
  • 8
  • 9
  • 10
  • …
  • 92
Next
First Prev 8 of 92 Next Last
You must log in or register to reply here.

Similar threads

Shifting Issues - Tremec 3650
  • KingCobra2001
  • Jul 13, 2005
  • SVT Tech Forum
Replies
1
Views
3K
SVT Tech Forum Jul 13, 2005
COBRA90GT
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?