Well mate if your oil pressure did drop very low there is a good chance something was oil starved.NO, I got a lil nervous so I just put more oil in, the hand went back to normal and then drop back down, now it sound like my chain isnt getting oil or something, i have a loud clicking sound now
Yes It gets louder when engine speed is increased, please dont tell me its the chain!?Is the click consistent, or does it get faster and/or louder when the engine's speed is increased?
Yes consistent clickingYes It gets louder when engine speed is increased, please dont tell me its the chain!?
I believe your right, ok so the next best thing is to get new Main Bearing and Rod Bearing, alone with a timing chain set right!?Can you post a video of the sound?
If the engine was running without oil pressure for any length of time, especially under load, I'd be more worried about rod bearings than the timing chains. Journal bearings (like the rods and mains) require pressurized oil to survive whereas the timing chain only requires splash lubrication. If the oil pressure goes away due to a low level (e.g.) you're more likely to hurt the bottom end than the timing chains which will stay oily for quite a while even without pressure..
Please post a vid for more help.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?