A little over a month ago i did switched to a cobra intake on my 87 and i also put an accufab tb on there at the same time. About two weeks after that the car started smoking when I started it up and i could not figure out why. So the other day the tb started sticking so i went in to clean it and found that i am getting oil sucked up into the tb and into the intake.
Now i know that this is obviously causing my smoking problem but i cannot figure out why im getting oil in there. When i put the intake on i replaced the pcv valve, screen and grommit as well as all the vaccum lines.
I dont know if this could effect it but i also disconnected the egr and got rid of all the smog pump lines and capped off all the vac lines that were used for them.
I'm really not looking forward to taking the intake back off since its not exactly warm out, but i know im gonna have to. I just need some idea as to what im looking for when i get in there cause im drawing a blank.
Any help would be greatly appreciated.
Thanks.
Now i know that this is obviously causing my smoking problem but i cannot figure out why im getting oil in there. When i put the intake on i replaced the pcv valve, screen and grommit as well as all the vaccum lines.
I dont know if this could effect it but i also disconnected the egr and got rid of all the smog pump lines and capped off all the vac lines that were used for them.
I'm really not looking forward to taking the intake back off since its not exactly warm out, but i know im gonna have to. I just need some idea as to what im looking for when i get in there cause im drawing a blank.
Any help would be greatly appreciated.
Thanks.