oil pressure sending unit "need part that goes into the block"

[85/96gt]

hey guys i posted somthing on this already but my question wasnt really answerd.. i need an oil pressure sending unit for my 85 mustang.. you guys said could get it at autozone ed.. im missing al of it tho ..i neeed the plumbing that goes into the block ware do i get that?? make one? junkyard? they dont sell that do they.. that does not coem with the iol pressure sending unit im assuming.?

 

[79'293stang]

buy a mechanical oil pressure gauge it comes with a fitting the runs a line to the gauge thats what i did depends on if u wanna run a hard line or not but its more accurate, you can buy them at any auto parts store u go into

 

[408stroker5.0]

The Ford Part Number for what you need is a C20Z-9B339-A. Unfortunatly there is No Stock in any Ford USA warehouse. Phone your local Ford Dealer, give them the Part Number and tell them to try and find one for you.... they may be able to locate one from another dealer or just S.O. order it.

 

[shttygtstang]

y would you want that plum an after market in there

 

[HISSIN50]

if yours is like the 87+'s motors, you are looking for the 'hex tube' which screws into the block. it has a female fitting for the male sender to screw into......?

that was my take, but either im wrong or others did not get that.

if so, id try a J/Y or fab one up yourself.

good luck.

 

[Jeff Cardwell]

Hello HISSIN50,
The oil sending unit out of a 1996 Explorer with a 302 is smaller than the Mustang sending unit. The Explorer is small enough to just screw into the block without the hex tube and clear the oil filter. Hope this Helps.

Jeff Cardwell
www.ThunderValleyMustangs.com