• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

oil pump

  • Thread starter Thread starter stevesLX
  • Start date Start date Mar 21, 2007

stevesLX

Member
Nov 12, 2006
373
0
16
cincinnati
Mar 21, 2007
#1
  • Mar 21, 2007
  • #1
How can you tell if you have a bad oil pump. Is there anyway of testing one to see if its bad other than going off the oil pressure guage.
 

Jason 302

10 Year Member
Aug 9, 2003
685
71
68
Newark, Ohio
Mar 21, 2007
#2
  • Mar 21, 2007
  • #2
The best way I can think of would require some work. I would hook a mechanical gauge into the oil port (just in front of the oil filter). It would be kinda hard to get to with the motor in the car, and you would have to remove the oil sending unit. Then I would remove the distributor, get an electric drill, put a long extension on it with a small OD 1/4" deep well socket, and start cranking it (counter clockwise I believe). Just watch the gauge for pressure, depending on how fast your drill is turning (it will take a strong one) you should have at least 20psi I would say, my car as around 50 when it's running but drops to around 10-15 if it starts to idle too low (600-700).
 

NKau

Founding Member
Dec 15, 2001
1,346
0
37
Jefferson, WI
Mar 21, 2007
#3
  • Mar 21, 2007
  • #3
Good advice from Jason. Just be sure if you use a 1/4" socket, that it is SECURED to the extension. Don't want that thing falling off inside your engine. Are you making no oil pressure, or just low oil pressure? Typically if a pump goes bad, it just locks up; I don't think they just start making 'less pressure'.
 

stevesLX

Member
Nov 12, 2006
373
0
16
cincinnati
Mar 21, 2007
#4
  • Mar 21, 2007
  • #4
O.K. well I do know this much its a high volume oil pump thats in there right now. Its what was in there when I bought the car back in NOV. When I was putting my motor back in last month I crushed the oil pan a little bit nothing that I think is super major. Is there a chance that I damaged the pick up tube when I did this and that it has finally acted up and its been my problem all along with the lifters being noisy even though until yestarday I had no oil pressure problems at all. As a matter of fact at hywy speeds my pressure until yestarday was holding at 70psi and at idle 40. I have been told that the high volume pumps cause problems and that all that motor needs is a standard pump. I only have 600 miles on this motor since I had it rebuilt. Also is it necessary to pull the motor in order to change the pump?
 
You must log in or register to reply here.

Similar threads

Engine Looking for suggestions and or ideas
  • PonyGTrider
  • Aug 25, 2026
  • Fox 5.0 Mustang Tech
Replies
17
Views
747
Fox 5.0 Mustang Tech Sep 7, 2026
PonyGTrider
B
Engine Strange Noise
  • burntokita
  • May 8, 2026
  • Fox 5.0 Mustang Tech
Replies
8
Views
566
Fox 5.0 Mustang Tech May 11, 2026
keel
A
Resolved 302 oil leak when running
  • AlexM556
  • Sep 8, 2026
  • Classic Mustang Specific Tech
  • 2
Replies
36
Views
1K
Classic Mustang Specific Tech Nov 1, 2026
manicmechanic007
Fox Help
  • 93fox85
  • Mar 22, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
5
Views
332
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Mar 23, 2026
Noobz347
S
92 5.0 almost starts
  • Steverino
  • Sep 23, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
5
Views
283
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Sep 25, 2026
General karthief
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?