- Feb 13, 2009
- 60
- 0
- 6
Can anyone tell me about the install? What needs to be cut? Should I have a shop install it? I ordered the prepainted classic. Thanks in advance.
Ordered my CDC chin spoiler.
- Thread starter 06GTWhiteHorse
- Start date
Casey4s
New Member
I don't believe there is any cutting involved for the "Classic". Just follow the instructions.
cycosarge
New Member
No cutting dude, 3M tape and some prep work. took me 15 minutes start to finish. Easier if you take off the front two wheels.
Humboldt Stang
Member
- Nov 5, 2005
- 64
- 0
- 6
Too easy.
3M tape in the middle and held on by existing screws on the ends.
No cutting.
I just cranked the wheels to the side(s) instead of removing them, used a shorty screwdriver.
What's you'll need:
Shorty screwdriver
Alcohol for prep
A beer
15 minutes of time (5-10 for the install, 5 to admire your work and finish the beer)
3M tape in the middle and held on by existing screws on the ends.
No cutting.
I just cranked the wheels to the side(s) instead of removing them, used a shorty screwdriver.
What's you'll need:
Shorty screwdriver
Alcohol for prep
A beer
15 minutes of time (5-10 for the install, 5 to admire your work and finish the beer)
- Feb 13, 2009
- 60
- 0
- 6
Humboldt, you are too funny!! thanks again everyone! the job does not sound too seriuos.... But just in case I am going to bring more than one beer... Unless its a fourty! :SNSign:
kooldawg6
mine works really well and can take a fair amount
Humboldt is right
I also just turned the wheels ( a few seconds is all you need and works just as well) to gain access to the screws.
I also just turned the wheels ( a few seconds is all you need and works just as well) to gain access to the screws.