• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 1994 - 1995 Specific Tech

Over Heating because of air

  • Thread starter Thread starter Michael87
  • Start date Start date Oct 14, 2008
M

Michael87

New Member
Jun 3, 2008
2
0
0
Canada
Oct 14, 2008
#1
  • Oct 14, 2008
  • #1
Hey,

I have a 1994 Mustang Gt 5.0. Does anyone know how to bleed the air out of the cooling system. I have air in the system and if i do not have the heater on in the car it will overheat. Thank you:SNSign:
 

Dino Dino Bambino

15 Year Member
Jun 13, 2007
1,672
89
79
Cyprus
Oct 14, 2008
#2
  • Oct 14, 2008
  • #2
The cooling system should be able to "burp" itself but if yours doesn't, try running the engine next time till it's fully warmed up and then park it for a few hours facing uphill. Any remaining air inside the engine should come out through the upper radiator hose.
 

94-302-vert

Active Member
Aug 16, 2004
1,947
2
36
NE CT
Oct 14, 2008
#3
  • Oct 14, 2008
  • #3
Park aimed uphill. With a cool engine open the radiator cap then begin squeezing the upper radiator hose. You can get rid of most of the air this way, at least until the point it will burp itself.

Are you sure you Tstat is not the problem?
 
S

ShawGS

New Member
Sep 12, 2008
5
0
0
Oct 14, 2008
#4
  • Oct 14, 2008
  • #4
Cooling Problems - Stock 95 GT

Michael87 said:
Hey,

I have a 1994 Mustang Gt 5.0. Does anyone know how to bleed the air out of the cooling system. I have air in the system and if i do not have the heater on in the car it will overheat. Thank you:SNSign:
Click to expand...

Was going to be my topic as well. Have replaced the thermostat and bypass hose and the temp still wants to creep up and then drop like a rock before coming back to midpoint. The fan works when it reaches op temp and both upper and lower hoses get nice n warm when brought to op temp. Drained coolant looks nice n green without any rust or particles in it so I'm not thinking water pump or clog issue (yet). If it is air is there a DIY way that does not result in parking it "uphill"? I live in a pretty flat town and don't feel like driving 50 miles to the nearest anthill. :SNSign:
 

Adam95GT

New Member
Aug 14, 2006
2,564
3
0
Burlington, NJ
Oct 14, 2008
#5
  • Oct 14, 2008
  • #5
ShawGS said:
Was going to be my topic as well. Have replaced the thermostat and bypass hose and the temp still wants to creep up and then drop like a rock before coming back to midpoint. The fan works when it reaches op temp and both upper and lower hoses get nice n warm when brought to op temp. Drained coolant looks nice n green without any rust or particles in it so I'm not thinking water pump or clog issue (yet). If it is air is there a DIY way that does not result in parking it "uphill"? I live in a pretty flat town and don't feel like driving 50 miles to the nearest anthill. :SNSign:
Click to expand...

could always jack up the front end../??
 
S

sl03gt

20+ Year Stangneter
Sep 29, 2003
182
1
18
Oct 14, 2008
#6
  • Oct 14, 2008
  • #6
That's what I had to do. I jacked up the front and kpet on bleeding, there was ton of air.


Adam95GT said:
could always jack up the front end../??
Click to expand...
 

94-302-vert

Active Member
Aug 16, 2004
1,947
2
36
NE CT
Oct 15, 2008
#7
  • Oct 15, 2008
  • #7
Honestly for this i put the car in my driveway which is fairly flat (car will BARELY roll if in Neutral) and then pump the air out with my hand, fill the overflow and take it for a drive... nice and easy... usually it will build up really hot once then cool and after 1-2 of these cycles it is fine...
 

desertcox05

New Member
Oct 3, 2007
379
0
0
south atlanta
Oct 15, 2008
#8
  • Oct 15, 2008
  • #8
all good info. also run it with the cap off. and when the stat opens the air will push it's way out. you may lose some coolant when this happens but don't panic. when the level drops back down put some more coolant back in and keep watching. the t-stat only reads water temp and not air so when the air goes past it, it will close and the level in the rad will go back down again. you may have to top off the rad this way 3-4 times. then put the cap on and take for a drive let the motor cool and ck the rad again, and top off if necessary. don't leave the antifreeze where any pet can come into contact with it.
 
M

madams74

Founding Member
Jan 26, 2002
664
1
17
Maryville, TN
Oct 16, 2008
#9
  • Oct 16, 2008
  • #9
A
 
You must log in or register to reply here.

Similar threads

B
A/C Issues
  • Boats90GT
  • Jun 10, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
2
Views
109
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jun 11, 2026
Mcmahst
Engine Bleeding air in the heater core
  • keel
  • Apr 2, 2026
  • Fox 5.0 Mustang Tech
Replies
10
Views
243
Fox 5.0 Mustang Tech Apr 23, 2026
limp
J
Mustang 1968 coupé restoration hvac
  • JackStang68
  • Mar 3, 2026
  • 1965 - 1973 Classic Mustangs -General/Talk-
Replies
1
Views
144
1965 - 1973 Classic Mustangs -General/Talk- Mar 27, 2026
zookeeper
D
AC Circulation
  • Dtn520
  • Jun 26, 2026
  • The Welcome Wagon
Replies
1
Views
77
The Welcome Wagon Jun 27, 2026
LILCBRA
What should I do
  • PvolkStang
  • May 21, 2025
  • 1994 - 1995 Specific Tech
Replies
7
Views
284
1994 - 1995 Specific Tech May 22, 2025
WhiteCobra95
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 1994 - 1995 Specific Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?