pcv question

68keyblr

20+ Year Stangneter :roc</strong><span class=
Mar 17, 2003
946
20
49
Arizona
I'm trying to hook up all of the vacuum hoses to the '93 cobra intake that I bought.

There's a fitting underneath the upper intake on the driver's side toward the back. I know the PCV hose from the lower intake connects to one side of the fitting...but where does the hose on other side of the fitting go to?
 
So one end goes to PCV on lower intake and the other end goes to vac tree? Can I cap off the vac tree end like cenok?

One other question - the heater tubes that run down the manifold by the passenger side valve cover has 2 hose outlets that used to go to the old EGR spacer - one to the front and one to the back.

The Cobra intake has only the front one - nothing in the back. Where do I hook up the back hose? Or can I just cap them off ?
 
Correction - only one small nipple on the heater tube that goes to the front of the EGR spacer. The lower manifold has a fitting at the passenger side rear that connects to a hose that goes to the back of the EGR spacer.

The new cobra lower had a plug in place of the fitting on the lower manifold.

So can I just plug these fittings and remove the hoses to the EGR ? What's the downside?
 
Yea you can plug off that vac line. But then you won't have vac going to any thing that runs off that vac tree. As far as the other to egr spacer hoses i pluged mine. Will help keep the air intake temp. down.