I'm doing the PI intake swap on my 97 GT. Do I have to tap my intake for the second temp sensor or can I just leave that unplugged? What will the results be if I leave it unplugged? Thanks for any help and suggestions.
The temp sensor for the gauge is on the passanger side, the one that goes in the aluminum crossover is for the EEC. You can put the EEC one on the left if you stretch the wiring harness out far enough as you need that one in. The gauge one you can leave out, but you may as well do it right and get the crossover tapped as it's tough to do later when the intake is on the engine.blowbyu97 said:I'm doing the PI intake swap on my 97 GT. Do I have to tap my intake for the second temp sensor or can I just leave that unplugged? What will the results be if I leave it unplugged? Thanks for any help and suggestions.
tomustang said:buy a T fitting for the 1 hole. it adds 31rwhp.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?