• Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech

Please Help!!!!97 Cobra sparkplug holes filled with oil???

  • Thread starter Thread starter EPIK
  • Start date Start date Nov 20, 2005

EPIK

Member
Jul 3, 2004
796
1
16
LEFT COAST
Nov 20, 2005
#1
  • Nov 20, 2005
  • #1
I recently purchased a 97 cobra with 88,000 miles on it. Today I pulled the sparkplug wires on my driver side to check if my plugs were good and all of the holes were filled with oil. What causes this, and is it a common problem? Is it something major? You guys are my only source of income besides the magazines, because none of my freinds own stangs (their loss), and the local mustang shops dont want to offer much help unless your buying stuff. Any help would be greatly appreciated.
 

chris kelvin

New Member
Sep 11, 2005
67
0
0
Nov 20, 2005
#2
  • Nov 20, 2005
  • #2
Well i doubt someone putting a full quart over the oil level would make oil shoot up into the cylinder and in the plug area...this leads me to one thing i know from experiance when i worked at autozone for a short while..

I'm guessing the tard that filled the oil up didn't use a funnel, and it spilled all over the head/plug area/boot etc...then he/she wiped it away. Let me guess, is the oil in the plug holes the two that are close to the refill neck...? It's very easy to get oil in there if you spilled a half a cup-which i seen everyday at autozone...lol.

DEFINETLY get a strong compressed air source, not just a can with air in it-they suck. Go to a shop, or get someones that has a compresser to use a air hose to blow out the holdes WHILE the plugs are still in there. Then removed the plugs and use a cloth/rag to clean the rest...make sure it's a cloth that doesn't shed, so you wont get stuff in the combustion chamber.
 

EPIK

Member
Jul 3, 2004
796
1
16
LEFT COAST
Nov 20, 2005
#3
  • Nov 20, 2005
  • #3
Well I did get the oil changed right away when I bought the car, but I watched them do it and dont remember seeing them spill oil. Besides, it was in all of the plug holes on the driver side, not just the ones near the filler neck. Could this be a bad valve cover gasket?
 

chris kelvin

New Member
Sep 11, 2005
67
0
0
Nov 20, 2005
#4
  • Nov 20, 2005
  • #4
I'm sorry, others will shine in on this. But i seriously think someone simply dropped a quart, and it spilled all over your engine..on the drivers side. I'm not saying the person that just changed it did it....that oil in the plug holes could have been there for over 6 months.

I can be wrong on this, but i do believe you'd have ALOT of symptoms if you had a bad valve cover gasket...

Mustang guys, please help..lol.
 

Mark8Denny

New Member
Apr 28, 2004
6
0
0
Nov 21, 2005
#5
  • Nov 21, 2005
  • #5
oil in the spark plug wells

You need new valve cover gaskets. The spark plug wells have a rubber o ring to seperate them from the camshaft area under the valvecover.
 

billfisher

Active Member
Jul 17, 2005
1,296
4
38
huntsville, AL
Nov 21, 2005
#6
  • Nov 21, 2005
  • #6
possible leaking spark plug to valve cover seals. easy to fix dude. no sweat. or a spill. clean it out good and if it returns, change the seals and valve cover gasket. piece of pie.
 
D

Dragstr05

New Member
Dec 21, 2004
643
1
0
Stafford VA
Nov 21, 2005
#7
  • Nov 21, 2005
  • #7
Probably the the O seals around the plug holes in the valvecover. I replaced a few valvecover gaskets at lincoln for this same problem.
 

EPIK

Member
Jul 3, 2004
796
1
16
LEFT COAST
Nov 21, 2005
#8
  • Nov 21, 2005
  • #8
Today I checked the passenger side plug wires and those are soaked also. Hopefully you guys are right about the valve cover gaskets and seals. I just bought this thing not less than a month ago, and I already got problems. The only problem my 96 gt had when I got it was the stupid intake recall,and ford took care of that. So this is a common problem with all dohc engines? What other common problems do these engines have(4.6 dohc)?
 

billfisher

Active Member
Jul 17, 2005
1,296
4
38
huntsville, AL
Nov 21, 2005
#9
  • Nov 21, 2005
  • #9
it can only be a leak or cracked covers. once neoprene get hot enough it loses flexibility. or if they are hard and someone took them off to look inside they won't seal again. no matter what you don't have a big deal.
 
You must log in or register to reply here.

Similar threads

SN Mustang Magnum T56 swap
  • revhead347
  • May 24, 2024
  • 1994 - 1995 Specific Tech
Replies
15
Views
6K
1994 - 1995 Specific Tech Jun 28, 2026
GearHeadGuy
B
Header Bolt Snapped off Please help
  • Bayless72
  • Sep 19, 2022
  • 2005 - 2009 Specific Tech
Replies
3
Views
3K
2005 - 2009 Specific Tech Sep 25, 2022
chrlsful
C
D
Engine I need help with PCV routing on a 1995 Cobra with supercharger
  • Duff
  • Oct 13, 2021
  • Fox 5.0 Mustang Tech
Replies
1
Views
1K
Fox 5.0 Mustang Tech Oct 18, 2021
Duff
D
M
Help
  • Mustan@97gt
  • Mar 14, 2020
  • SN95 4.6L Mustang Tech
Replies
9
Views
994
SN95 4.6L Mustang Tech Mar 20, 2020
General karthief
P
Help please!!! Coolant crossover 4.6 4v
  • petemakmt
  • Sep 26, 2020
  • SN95 4.6L Mustang Tech
Replies
2
Views
4K
SN95 4.6L Mustang Tech Oct 15, 2020
DaveWertz
D
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?