Ok my power locks have never worked sence i owned the car, i was just wondering on what i could do to check it out??? do i need to replace the locks switches on the door?? no clue on what to look for?? any help thanks???
Power locks dont work???
- Thread starter Jaswir
- Start date
bubba-dough
Active Member
Check the fuses first. Chances are the actuators are bad. As this is the case for most foxes. Direct replacements are kinda expensive but I went a very cheap route by getting them through Parts Express. Some one has a step by step on this. I will try to find the link for ya.
here ya go http://bellsouthpwp.net/l/r/lrichker/Mustang_tech/door_actuator_fix/1_of_8_door_actuator.htm
here ya go http://bellsouthpwp.net/l/r/lrichker/Mustang_tech/door_actuator_fix/1_of_8_door_actuator.htm
darthcual
Member
also a good link on 50resto.com to replace the actuator in the door. Your gonna need a rivet gun!
The main connectors for the lock wiring is at the top of the driver side kick panel. I would see what values you have at those wires and go from there. Be sure the door panels have their central ground wire attached as well.
Good luck.
Good luck.
my door locks didn't work either when i got my 88.it had 2 problems.first was the driver door actuator was froze so replaced both of them with ford ones($90 apiece but worth it).still no locks,i repaced both switchs with ford ones and i could lock the doors but no unlock.finally found a broke wire in the drivers door and voila we had functional door locks after spending over $250 in parts but at least they work now.at least fixing the power mirrors was less expensive at only $20 for a new ford power mirror switch.
Similar threads
