power problem with engine?

1990 gt when i push on the gas it doesnt seem to have the power that it normally does. It almost sounds like a flutter when you hit the gas. is that the exhaust of could something be wrong like the plugs, wires or something else with the engine?
 
i'll probably be just the first of many to suggest you dump the codes first. your description doesnt help much either. my first guess may be something with your egr system, but you dont have enough info to really tell.
 
well i don't get what "it almost sounds like a flutter" means. what is sounding like a flutter? what does a flutter sound like? where is the noise coming from? any other noticeable symptoms? when do you lose power? full throttle, part? high rpm/low is car stumbling/bucking....? etc., anything else?
 
ok b flutter i mean when i floor the gas at any speed it almost hesitates/takes it time reacting to me hitting the gas. There are no other symptoms or anything and this just started on my lunch before that it was fine. I guess it can be considered a slight hesitation. all fluids are fine. This happens at any spped i am going. Starting out and while the rpms are up.
 
Sounds like you just need a tune up, do that and set the base timing between 12-14* (if you run 93 octane) It will wake your car up. I had to do the same when I first got mine!

Usually you can drive it out of the hesitatiion, it really only happens when the motor is under load.......but its a pretty inexpensive fix.
 
Dump the codes and see what the computer says is wrong…Codes may be present in the computer even if the Check Engine light isn’t on.

Here's the link to dump the computer codes with only a jumper wire or paper clip and the check engine light, or test light or voltmeter. I’ve used it for years, and it works great. You watch the flashing test lamp or Check Engine Light and count the flashes.

See http://www.troublecodes.net/Ford/

index.php


index.php


IF your car is an 86-88 stang, you'll have to use the test lamp or voltmeter method. There is no functional check engine light on the 86-88's except possibly the Cali Mass Air cars.

attachment.php


89 through 95 cars have a working Check Engine light. Watch it instead of using a test lamp.

attachment.php


Codes have different answers if the engine is running from the answers that it has when the engine isn't running. It helps a lot to know if you had the engine running when you ran the test.

Trouble codes are either 2 digit or 3 digit, there are no cars that use both 2 digit codes and 3 digit codes.

For those who are intimidated by all the wires & connections, see http://www.actron.com/product_detail.php?pid=16153 for what a typical hand scanner looks like. Normal retail price is about $30 or so at AutoZone or Wal-Mart.

Or for a nicer scanner see http://www.midwayautosupply.com/pc-7208-90-equus-digital-ford-code-reader-3145.aspx – It has a 3 digit LCD display so that you don’t have to count flashes or beeps.. Cost is $30.

Or for a nicer scanner see http://www.midwayautosupply.com/pc-7208-90-equus-digital-ford-code-reader-3145.aspx – It has a 3 digit LCD display so that you don’t have to count flashes or beeps.. Cost is $30.