Pre Vortech Install Question

2002BLGT said:

only thing about the engine I can recommend is changing to a BR7EF ngk plug , TR6s will work if you cant find a the BR7EF , what fuel pump are you using , I hope not the one with the kit they aren't really reliable , get a svt focus pump in there , I have one for sale if you want , its brand new , 100 bucks shipped , PM me if you are interested .... other thing would be getting a wideband hooked up to check the air/fuel ratio checked if you are getting the chip or flasher from vortech , if the tune is off you will probably want to get a custom tune done , and you will want to relocate the IAT sensor in the pipe after the cooler right before the throttle body so that is properly reads the air temps going in the motor , on the 02 and newer cars the IAT is built in the stock MAF so you will have to pull the far outside 2 wires out of the MAF wiring harness and run them a push in IAT that you can get for a F150 or expedition. hot glue gun and black tape works good to hold the terminals on , if you have to extend the wires make sure you solder them and then use heat shrink , and get a toyota PCV grommet works good to hold it in place and will give a nice factory looking install .......

Click to expand...