Moroso makes a oil priming tool. Check out summit! Good Luck
The tool is 10 bucks.
I watched my oil prime up two ways. I pulled off my oil cap (no baffle) and watched the oil flow out of the pushrod, you see it run onto the head. Also I primed the key (accessory) and watched it rise on the factory guages...
The tool is 10 bucks.
I watched my oil prime up two ways. I pulled off my oil cap (no baffle) and watched the oil flow out of the pushrod, you see it run onto the head. Also I primed the key (accessory) and watched it rise on the factory guages...
I just used several 12" 1/4 drive ratchet extenstions that I taped together, so they wouldn't fall apart. If you have the funds and patients, it would be best to get the right tool though.
Then just chuck it up to a drill motor, and make sure you are spinning in the correct direction.
You should feel the drill motor bog down after several seconds, but it may take a minute or so.
I am not sure you will see oil pressure register while priming?
It will depend on the output of the drill motor you use.
jason
Then just chuck it up to a drill motor, and make sure you are spinning in the correct direction.
You should feel the drill motor bog down after several seconds, but it may take a minute or so.
I am not sure you will see oil pressure register while priming?
It will depend on the output of the drill motor you use.
jason