85 Canister purge (CANP) circuit fault
67 Neutral drive switch drive or accelerator on (engine off)
It is an 88 with an 89 motor and MAF. I don't even have the cannister hooked up to the intake at any point. Where is the valve located at?90mustangGT said:An 88 with a EVAP pressure sensor in a 1988? I think someone is thinking OBDII here. That is a canister purge circuit failure, its probally the valve. You don't even need the canister there, it only detects the operation of the switch.
Check the tps Voltage and operation of the TPS, then be sure the Neutral switch which operates like a brake switch, isn't permenently on. It either detects the clutch is alway in or out, it's one or the other.
kewl thanks. It used to be a 4 cyl so the canister line for the intake goes to the back on the engine where I have that vacuum line behind the dizzy capped off because I didn't know where it went. Thanks everyone for the help. I will get that put on and see if it drops the code. Then I will try it running and see what happens.postalbunny said:I think its Green wire to pos and at rest you want as close to .99 as possible and full throttle should be 4.5
The cannister hooks up to a hose that I have to cramp my hand in the cubby hole under the upper intake to get to. I can barely push that bad boy on... it's the cubby behind the distributor i'm talkin 'bout.