Ok heres the story. This car has not ran in 12 years. It is an 86 f.i. all stock. It has been stored in a dry garage. I was freshining up the top end with new gaskets, etc. I pulled of the lower intake and on the very rear two ports there was milk in them. They were on both sides of the motor. Below is a pic of the rear of the lower intake gasket. The two very front ports look like they make have a very fine film of milk in them. Does this sound like a bad gasket or a cracked head or head gasket? I want to find out now while the motor is all apart. There was very little oil in the oil pan because the drain plug was stripped, but I have not seen any evidence of water in the pan. Where do I go from here?