pulley kits..

Arsonstang · May 30, 2005

What do i all need to install a pulley set? Do the stock belts work?

wytstang · May 30, 2005

An impact gun to remove the alt. pulley. Or remove your alt take it a discount and they will R&R it for you.

BULLITTSTANG95 · May 30, 2005

i assume you are talking about u/d pulleys and that it is on a 94/95 5.0. if so then all it is ...pull off the belt then take off the old pulleys and replace them with the u/d pulleys. stock belt works with them. very easy i just did it about 3 weeks ago

Hef5.0weisen · May 30, 2005

stock belt will work fine, but I'd loosen the the W/P and crank pulley's with the belt still on, helps to keep the pulleys from spinning while breakung the torque on the fasteners, good luck

super302 · May 30, 2005

robertdale · May 30, 2005

Yep pretty easy job just don't get in a big hurry and bust a knuckle.

HGFireHazard · May 30, 2005

On the topic of UD pulleys, I have been looking to get a set, but everytime I go to a website to order some, I see them up to the year 93 and then 96- whatever, where have you guys ordered them from? Other than different brands and types of material, are there any real differences between pulleys? Thanks guys.

BlackVert · May 30, 2005

HGFireHazard said:
On the topic of UD pulleys, I have been looking to get a set, but everytime I go to a website to order some, I see them up to the year 93 and then 96- whatever, where have you guys ordered them from? Other than different brands and types of material, are there any real differences between pulleys? Thanks guys.

the 94/95 motor is not compatible with pre-94 pulleys. summit has them. lots of folks buy asp pulleys. i have bbk's. i recommend getting aluminum ones, they are lighter and have less rotational inertia.

FlyBy763 · May 30, 2005

www.thunderracing.com

but theyre backordered, i just ordered mine on wednesday.

Arsonstang · May 31, 2005

I just ordered the BBK Polished Aluminum pulleys from Jegs... how much time would it take off in the 1/4, i run a 14.8 @ 92mph

MysteryMachine · May 31, 2005

BlackVert said:
the 94/95 motor is not compatible with pre-94 pulleys. summit has them. lots of folks buy asp pulleys. i have bbk's. i recommend getting aluminum ones, they are lighter and have less rotational inertia.

i was told that they wouldn't work when i asked back when i bought mine

pulley kits..

Arsonstang

New Member

wytstang

Mustang Master

BULLITTSTANG95

New Member

Hef5.0weisen

super302

I'd do anything for free Bapples

robertdale

New Member

HGFireHazard

Member

BlackVert

FlyBy763

Member

Arsonstang

New Member

MysteryMachine

Active Member

Similar threads

pulley kits..

New Member

Mustang Master

New Member

I'd do anything for free Bapples

New Member

Member

Member

New Member

Active Member

Similar threads

Privacy & Transparency

Privacy & Transparency