Pullies or JLT RAI?

[baller760]

Ok, I'm buying an accufab plenum and 75 mm throttle body, but I will still have a little money left. I can either get steeda pullies and POSSIBLY, I said POSSIBLY, a steeda timing adjuster. Or I can get JLT's new RAI which I have read and seen dynos of is pretty good. Do you think I should just finish off the intake side of my car and wait on the pullies? Are the pullies even worth the money? Also, do you think I should even get a timing adjuster or just wait until I get my 4.10s and a chip in the future to adjust my timing?

 

[nickthegenius]

I would do pullies before any sort of intake pipe.

 

[CPB00GT]

The Steeda pullies are a long proven mod. This has been shown time and again. I would get the pullies first.