pushrods for a 347

does the previous owner have the cam specs or know what the cam is called? the only real way to figure it out is to measure it. the heads dont matter much in this post, its the cam thats the "X" factor.
 
buy an adjustable checker for like $10 from a local parts store. measure it, buy the right length, get the pushrods. like i said, on BOTH edelbrock heads (Per. 2.02 valve and Vic jrs, 2.05 valves) and both cams (Comp Cams XE274 and my Custom Jay Allen) it was the same pushrod length both times!
 
347lxvert said:
what kind of motor do you have? did you change your cam when you changed your heads?
i have the stock 302, yes i did change my cam to a trick flow stg 1. heads and deck height play a very vital role in pushrod length. if you mill your deck or put on a thicker headgasket it will move your rokers further away resulting in a pushrod length delima.

long story short, find out how much he took off the block/heads and see if edelbrock says you may need a pushrod change.
 
The only way to tell what you need is to buy a pushrod length checker and set-up, measure and buy the right length.

Summit sells them for $10-$11 you'll need one that goes from a min of 6.25"

There are too many variables, deck height, head deck thickness, etc..